Your cart is empty.
Your cart is empty.
Rubber Material
Sturdy enough to support your lift point, at the same time soft enough to prevent crushing on the contact area.
Durable and not easy to bent.
Slotted Design
Adds extra grip when raising the car and reduces slipping.
For spreading the pressure over a wider area to provide more cushion and crush resistance.
No more damage to pinch welds, frame rails and coated chassis parts.
Installation
Insert the lift pad in to the frame rail slot, rotate, and release.
The pads will stay in position while the lift arm or floor jack is positioned.
Removal is done by slowly rotating the pad until the post aligns with the hole and they fall out.
Remember to recycle unused rubber pads in time to avoid loss.
Specifications
Quantity : 2/4 Packs
Length : 2.95 in / 7.5 cm
Width : 2.95 in / 7.5 cm
Height : 0.98 in / 2.5 cm
Color : Black
ANTHONY
2025-08-14 14:58:29
These fit perfectly on my Daytona 3 ton jack. I use it to get a little extra height when lifting my truck, time will tell how long they hold up.
Steve G.
2025-04-19 12:17:13
Easy to use. Works well for what I wanted them for. Good price. No problems or issues.
Cliente
2025-04-08 10:20:13
Excelente
Kimmy
2025-03-26 14:30:46
I bought these to keep a monitor from sliding and they work. Only problem is the smell but they are meant for outdoors or some type of garage work. The product works as described by keeping things from sliding.
AC
2025-02-09 13:00:54
No problems using these with floor jacks to lift a compact car. Have only used them twice, so I can't comment on the durability, but, thus far, they performed well after 2 lifts.
Glen Anthony
2025-01-13 15:33:47
I had a large scissor jack for an R.V. support. My truck came with a scissor jack about 1/3 the capacity and half the size. So I modified the scissor jack with a couple plates and mounted these on top for supporting a vehicle. Worked like a charm. And don't have to worry about bending thevpinch seam under the vehicle.
Mark Magda
2024-12-08 14:08:43
Used them once. My pinch welds went right through them. The company refunded my money and let me keep them... But I just wanted something that worked. I didn't want the money. Im giving them 2 stars because the customer service refunded me.... But only 2 because that doesn't fix the issue. I asked them for a solid block of the rubber they made these with. I would cut my own channel and I think I could have made them so they touched the body up around the punch welds and I don't think they would have cut through. The weight would have been more distributed. You can't take ANY chances when you're laying under a car.
Michael
2024-11-27 11:02:50
Used it for a spacer for my roof rack. Worked well for my purpose.
Recommended Products
