Your cart is empty.
Your cart is empty. eoere 4 PCS Steel Shim Beveled Washers 6 Degree Shim Suspension Leaf Spring Shim Kit, Underpinning Wedges, Tapered Wedges, Size: 6" x 2-5/8", Thickness: 2~7.6 mm
Note:
There might be slight oil stains on the surface of the steel shim. We recommend wiping it clean before use.
It is important to wear eye protection whenever driving a steel wedge.
Specification:
Material: Low Carbon Steel
Surface Treatment: Plain Finish
Appearance: smooth surface and edges without burrs, no sharp edging
Color: Dark Grey
Length: 6"(150 mm)
Width: 2-5/8"(67 mm)
Height(thick end): 7.6 mm(0.3")
Height(thin end): 2 mm(0.079")
Center Pin Hole Dia.: Ø22.5 mm(for 3/4" Extended Center Pin)
Weight: 0.79 lb(0.36 kg)-1 piece, 3.34 lb(1.52 kg)-4 pieces
Package Content:
4 x Steel Wedges
(Extended Center Pin NOT Included)
Felix
2025-08-08 18:35:53
Works good to shim or to adjust toe in/out. Good for HD trucks, i use mine to adjust height on one side of vnl volvo truck. Fit great and deliver-packaging was good.
B. Stanton
2025-07-22 11:24:04
They're steel wedges, not much to say. They are consistent, within a few thousandths of each other, and the angle is correct.
Ken Stein
2025-07-05 18:26:46
I spent way too long looking for 1.5 degree steel leaf spring shims on Amazon and finally found these. The angle looked suspiciously low for "6 degrees" as advertised so I did the math on the included dimensions and came up with 2.15 degrees. Decided to roll the dice and ordered. Luckily the description is wrong and the dimensions are right! Couldn't be happier with these unless they were 1.5 degree but I don't think anyone makes those in steel. Oh well. I'll settle for 2.15.
Kirk
2025-05-20 17:18:22
These are not 6 degree shims.
Viking Hot Rods
2025-02-25 12:27:35
These seem like they were made nicely, but the center holes vary position across the length slightly. Not an issue for my project, I will be welding them up smaller and redrilling to the smaller size I need. The metal itself is great, still has mill scale protecting all the non machines surfaces. Oversized so I can trim down and weld to axle perches. I would order them again, just wish the center hole was smaller to begin with. 4 out of 5 stars.
Customer
2025-02-23 14:13:20
The 4 pieces were within .003 of each other. The angles were saw cut and straight and square.
Customer
2025-01-04 16:58:14
Accurate angle, a little heavy ..but workAt setting pinion angle
Jason
2024-12-18 12:54:27
These shims are super strong and will stay in place. I like there is a hole in the middle in case you want to bolt them down. If you are getting these for a place that will be seen often, maybe get a stainless steel set. These come with freshly grinded metal and I had some rush on a few of them. These are going in the workshop, so it won't be an issue.
Recommended Products
