Your cart is empty.
Your cart is empty.Product Description
7" Universal Slim Fan Push Pull Electric Radiator Cooling Mount Kit
This is a great electric fan fits for radiators, oil coolers, transmission coolers, condensers and more. These powerful electric fans work with 12-volt electrical systems and draw 6 to 10 amps
Electric Cooling Radiator Fan Mounting Kit
Material: plastic, stainless steel
Suitable for installing transmission cooler and electric fan
The electric fan and transmission cooler installation kits to provide a solid trouble-free and installation-friendly method of securing an electric fan, transmission or engine oil cooler to any vehicle.
Puller and Pusher Design
Puller fans mount on the engine side (back) of the radiator core and pull air through the radiator core. The fresh airflow is pulled through the grille, then pulled through the core, and exits out the back side of the radiator. Puller fans are the desired and most common way of mounting a fan when space is not a limitation between the front of the engine and the back of the radiator core.
Pusher fans mount on the grille side (front) of the radiator core and push air through the radiator core. Fresh airflow enters through the grille, then is pushed through the radiator core, and exits out the back side of the radiator. Pusher fans are used typically where there is a limited amount of space for a properly sized puller fan.
Comes with fan mounting kit
Dual electric fan mounting tie-strap kit.
Fits all American Volt electric fans as well as other brands.
Heat resistant design for long lasting durability.
Mechanic
August 20, 2025
Installed this fan on an auxiliary cooler that is exposed to severe weather elements & it has performed flawlessly. Its small size delivers excellent air flow very impressed so far with how its held up to its working environment.
AB
July 29, 2025
Bought one of those $6000 minis. The air cooled engine inside a metal box was no good. Would get way to hot in as little as 15 mins of hard digging. The gas was boiling away and a hydraulic cylinder would burn your hand. Just a small 7" fan was all it needed to be able to run for continuous hours. Hydraulics stay cooler as well. Zip tied it to the existing vent and cut a new switch into the panel. Just make sure what ever you wire it to can handle the extra amps. I ran direct power from the battery as to not mess with the factory harness. Have to reveres the polarity and the fan blades to be effective. Moves more then enough air.
Jsturgell
July 20, 2025
This works really good. Moves lots of air
Ismael M. Hernandez
May 28, 2025
Remove and apply loctite to every nut or screw, including the fanblade nut. They will all back out while in use and fall out, if used on a motorcycle due to vibration. Being made of plastic, torquing down hardware will break it. Loctite allows light torque on hardware and keeps everything intact.
Poe Whiteboi
May 15, 2025
Incredible performance compared to the factory 8 inch radiator on my car would definitely buy again.
Samuel L Kuh
April 22, 2025
Used as an A/C cooling fan after adding AC to my jeep YJ. Needed a little more air through the front. Can be wired as push or pull.
christian f.
April 13, 2025
Works great although I needed a radiator fan the pushes the heat the opposite way so I feel dumb for buying this great product I didnt want to mess up my motorcycle and got the old one to work so all an all im happy!
Richard
January 14, 2025
I purchased this when I replaced my radiator on my tractor. I hooked the electrical leads to the headlights so when I turn on the headlights the fan runs. Tractor is staying cool.
Recommended Products
$21.99
$ 10 .99 $10.99