Your cart is empty.
Your cart is empty.Product Description
Accusize Key Type Drill Chucks
All parts are made of high-grade alloy steel and heat-treated resulting in great durability. They can be used on milling machines, drill presses, lathe machines, etc.
Accusize Key Type Drill Chucks are for lathe machines, drilling machines, tapping machines, milling machines, etc. They are not for hand drills.
Use the following table to figure the Jacobs Taper size of your machine.
D. Brown
2025-08-23 19:49:07
The chuck on my 35 year old floor drill press was no longer working well, sloppy and the key mostly didn't fit anymore. This chuck looked well made and a great value. It has met all of my requirements: very well made with excellent tolerances, no wobble, smooth operation and a high quality key. I have since sold the drill press and the buyer was convinced by the new chuck to complete the purchase. Clearly added value to an old machine.
Matthew
2025-08-21 11:18:31
Recently picked up a mid-range drill press second hand. The original chuck had been (badly) abused and was just shot. I pressed one of these on and checked it out. Grip was great, both on the taper and in the jaws. Runout (measured about 4" down a 3/8" steel pin) was under 0.005". Very satisfied with that -- don't have any way of knowing if they are all that good. The chuck key fits nicely and has a thick green plastic coating. No complaints so far!
Michael E. Shake
2025-08-16 18:04:34
I have a cheap Harbor Freight bench top drill press and the run out on the chuck was more than 1/16".I bought this hoping it would improve that and it did. It's a much more substantial chuck. I tried it with a1 1/2" forstner bit in pine and it drilled great. It had very little wobble and made a smooth hole. I still have run out but it's less and I'm sure it's mostly from the shaft being out in the drill press, not the chuck.
mike
2025-07-26 17:11:22
Works like a drill chuck
duelmom
2025-07-08 10:11:17
Smooth operation and precise enough for me, I got a total runout of about 5 thou measuring off of a drill bit.
Devil's Hand Diesel
2025-06-14 11:57:04
The media could not be loaded.
Kindle Customer
2025-04-16 10:58:51
Fast shipping, looks great seems very well made, fit my 12" bench top drill press like it was made for it!
Carlos T.
2025-04-13 13:12:01
I was looking for a repalcement chuck for my Delta Drill press that is about 20 years old that look brand new as it was barely used however the JT33 chuck on it was jammed and had a missing key. I removed it and tried this chuck after no luck finding one local to me. Fit without issue. This is a great upgrade as now I can accept bigger bits the old could not do.
Barry M.
2025-04-09 13:54:45
I like the drill chuck seems to be of good quality. I use it in my drill press . I'm happy with It. I really don't like junk thanks.
angelika
2025-03-29 12:44:48
Replaced the chuck on my Rockwell drillpress, this chuck fit the taper well and has very low runout.Prompt shipping and delivery!
john mcfarlane
2024-11-26 12:55:11
Arrived one day ahead of schedule. Runout tested with a dial gauge. 0.001inches. (O.0254mm). That is good enough for me.
Recommended Products