Your cart is empty.
Your cart is empty. Description:
Material: body (aluminum die-casting products), cup (polycarbonate)
Port size: G1 / 4
Gauge caliber: G1 / 8
Operating pressure range: 0 ~ 1.0MPa (manual drain: 0-9.5kgf / cm2, differential pressure discharge: 1.5-9.5kgf / cm2)
Length: appox 16cm
Installation and Use :
1. The gauge reflects the working pressure of the air tools.
2. Pull the top button up; turn clockwise to increase the pressure; turn counter-clockwise to release the pressure.
3. Push the bottom needle to release the water.
Package Includes:
1x Regulator with Gauge & Water Trap Filter
2X 1/8"-1/4"BSP Adaptor
1X Wall Mount Bracket
TuneRaider
2025-07-20 13:12:54
Only replaced the defective pressure gauge on my compressor for now. I don't remember seeing it listed or pictured but there was a small roll of thin Teflon tape included. Bonus.
OZARK TWO
2025-06-28 17:28:39
works great, no problems , would order again
Ian F.
2025-05-26 14:43:01
Works great! Used thread tape to make sure it didn’t leak.
Steve Carter
2025-05-12 14:04:12
Bought this for my new airbrush set up. I’m pretty handy and understand how to thread male into female fittings. After threading the two fittings into their respective spots, both were at an angle. Which immediately indicates to me that they are cross threaded. I had used the plumbers tape and took my time since the body is made of plastic. Sure enough, really bad air leak on the inlet side. I had already thrown away the packaging so there’s no chance of a return, which is completely on me. Now it’s just trash.
mel50
2025-05-08 11:35:48
Works great for airbrush
cricman
2025-01-19 16:11:40
Bought two and one leaked internally due a flashing on the nylon washer that compresses the regulator diaphragm. It was an easy fix, but not everyone would know how to diagnose the issue and complete the repair.
Joseph Marquez
2025-01-13 16:43:02
I got this brand new, hooked it up to my compressor and it would not regulate past 20 psi. Sending it back.
C Bronson
2024-12-16 10:48:59
What arrived is just what I ordered and it arrived quickly.
digi
2024-12-01 11:21:34
Just replaced a broken pressure regulator with this on my Rollair compressor.Works as advertised, cheap product but is a little nicer than the one that came OEM with my compressor.The pressure setting knob is easy to turn, allows accurate adjustments and comfortable to use.I like the fact the gauge faces upward not forward, as normally you are looking down on a portable compressor.
Recommended Products
