Your cart is empty.
Your cart is empty.Product Description
Chain link fence gate corners are built from galvanized aluminum alloy, firm and not easy to deform, anti-rust for long-lasting use.
Easy snap-together construction saves you tons of time and money when building your fence gate. Easy DIY or on-site setup.
Suitable for 1-3/8" outside diameter pipe and have a 90-degree corner, will NOT fit other pipe size
Packing list:
4*pressed aluminum gate elbows.
12*Bolts
Suitable Size:
Fit 1 3/8" x 1 3/8" chain link fence gate corners or also known as gate elbows with 90 degree angle design.
Chain link gate corners are used for residential, commercial, and industrial gates.
Easy Installation:
Easy enough for a adult to install 10 minutes without any help. Installation for when building or repairing a chain link fence gate.
LB
2025-08-10 16:34:19
Did the job
Tamara Thomason
2025-07-11 16:10:03
Our gate's previous corners broke and these are so much better than what was on there before! They were very easy to install and seem to be very sturdy
Rocky Rawlins
2025-04-22 12:28:09
These corners are of such poor quality that if you tighten them enough to keep the rails from twisting they bracket cracks. Even tightened as tight as possible without cracking them a finger pushed against a corner twists the gate out of square.Having to replace every one of them with a better quality bracket. Complete waste of money.
Abuela
2025-03-06 15:07:35
The product fit our gate exactly and saved us $1,200!
Troy
2024-12-03 10:41:35
Even if you tighten down the clamps as much as possible, there's no through pin keeping the pipes from turning. This means the whole gate will be able to twist out of shape. I ended up drilling holds and putting through bolts to lock these in place. It's an imperfect solution. Avoid these and go with a better design.
Recommended Products