Your cart is empty.
Your cart is empty.Alfa Tools hand taps carbon steel - cut thread, right hand, bright finish. Ideal for hand threading in Routine maintenance, repair work and for Rethreading applications. Taper taps (7 to 10 threads) longest chamfer insures easier starting. Plug taps (3 to 5 threads). most common chamfer, used in through or Blind holes. Bottoming taps (1 to 2 threads). used for threading close to the bottom of a Blind hole.
Royce W. Johnson
2025-08-05 18:15:31
They are strong and sharp. The full set saved my bacon the other day when I had to drill outnabroken bolt and got off center whill drilling, leaving some of thenoriginal stainless bolt behind. The taper tap cut the threads anyway (always use oil and when you meet resistance, back the tap off and try again or you'll break off the tap in your hole!) and the blind hole tap allowed me to run threads all the way in to th bottom of the work-piece. Nice little case keeps them from getting lost in with the other taps.
Customer
2025-06-08 16:09:16
It’s a 1/4 x 20 tap
Adlers
2025-05-23 18:36:16
Flat bottom, tapered etcWorked ok , guessing Chinese quality though
william o'bryan
2025-05-10 16:40:11
The product pictures show taps with threads outside the shaft diameter. The taps received are not of this style. The threads on the taps received are the same diameter of the shaft, making it impossible to tap a hole more than about an 1" deep.
John B.
2024-12-24 19:32:19
nice replacements
Eric
2024-12-15 17:27:18
Have not used yet, purchased to replace damaged ones from my set but they look like good quality.
Darryl W
2024-12-05 20:33:38
Quality tool. saved my butt. I had a car in pieces and needed the taps fast.
Ira
2024-11-15 11:08:55
I was mistaken. The set did include a plug tap, but I didn't recognize it as the shank was the same diameter as the taper tap. I was looking for a tap where the shaft could clear the threaded portion. The photo showed one like that, but "plug" simply means less taper than a taper tap.
Recommended Products
