Your cart is empty.
Your cart is empty.Allstar 3/16 inch I.D Aluminum Clamp-On Style Universal Line Clamp (Pack of 4) are a clamp-on style with a 3/16 inch i.d. It has 2-piece quality aluminum clamps that dresses up wiring or hard fluid lines. It is sold in one set of 4 pieces. Other sizes are available and are sold separately..
Ron
2025-08-22 15:51:41
Nice product.
Customer
2025-07-11 14:30:45
These are great for fuel and brake lines
napoli
2025-07-10 16:12:22
simple and easy way to connect your 3/16" brake line to the body.
GranDoc
2025-07-06 18:40:43
These clamps fit the 3/8" OD aluminum tubing that I was working with just fine although, with the clamp completely tightened, the clamp does not firmly close on the tubing -- in other words, the clamp can still be moved on the 3/8" OD tubing when tightened to its limit. That's not good ... however putting a few wraps of tape or other 'lining' inside the clamp will take care of that.Worse, however, is the lock nuts that were supplied with the clamps. Either the screw/bolt or the locknut is not threaded right. Only 1 out of 4 clamps could be tightened down with the supplied hardware. The other 3 seized up while trying to tighten them beyond the first few turns. In addition, the locknut could not be backed off either -- so I had to cut the bolts with a hacksaw, remove them, and use alternative fastening hardware
Customer
2025-05-30 13:22:21
Used these to mount my stainless braided lines on my CBR1000RR. I ordered the wrong size but i drilled the to correct size and turned out great.
Big Bad Rob
2025-05-02 14:38:05
I couldn't find anywhere only what screw the 5/16 clamp came with. I wanted to make sure I have my nutsert tool with the appropriate size, which I don't. So I now will run to the hardware store and get some 10/24 screws.These are nice. I am using them to hold a parachute cable in a race car.
Tad
2025-04-11 11:36:02
Used this on a vintage motorcycle type project,and for what it's worth to the next guy, the bolts included/used are M4 x 0.7 thread.The machining is not perfect, I've had a few where I have take a file or carbide burr or drill or cut off wheel to slightly modify it, but not a big deal at all.Might be worth your time to check out Summit Racing or Jegs, both had a cheaper price than Amazon and they ship very fast.
D. Gaylord
2025-02-14 20:07:34
Used these along with anchors to mount a stainless steel wire shelf in my shower.
Andrew Steel
2025-01-29 21:46:48
Well machined and perfectly sized for the job.
Customer
2025-01-28 12:16:14
A plus
RogerWD
2025-01-08 12:30:59
Work as advertised.
Recommended Products
