Your cart is empty.
Your cart is empty.Product Description
- Double o-ring design; Blowout proof stem
- Teflon tape and thread sealant are recommended for threaded joints.
Designed for use in air, water, oil, nature, manufactured, mixed, liquefied petroleum or propane and LP Gas-Air supplying system.
Ball valves control the flow between pipes, tubes, or hoses by manual rotating 180° operation handle.
1/4" Hose Barb x 1/4" Hose Barb OR 5/16" Hose Barb x 5/16" Hose Barb
- 4-Pack Brass constrution shut-off valve, no leakage, durable and corrosion resistant, allowing it to withstand high pressure, temperature, and frequent daily use.
- 1/4 on the valve body is Not the valve thread size Only for style distinction by Manufacturer ! ! Please make sure you do not mind~
Train
2025-09-04 11:26:25
This valve is Excellent, I had bought those cheap plastic cut-off valves and they are junk. These are all Brass including the ball. I just hooked it up to my lawn mower after the cheap plastic one literally came apart spilling gas all over. This one is smooth operating and does Not Leak. I really like the 180 degree handle so it can be turned off on two directions if it is up against some object like my gas tank it can be orientated to operate as you need it to. I have not tested for long, but It seems to be well made and the handle is perfectly long enough to open and close the valve and it operates so smoothly. I do believe now I have the right cut-off valve for my small engines. Going to replace the other one on the tiller soon. And YES I do recommend these for small gasoline engines. I like them very much.
Sean Zanella
2025-07-05 13:40:18
just as described. works well.
luis rojas
2025-07-03 11:39:28
Perfect produce for water hose on kitchen equipment
HMMWV Adventures(on YT)
2025-06-11 17:43:57
I got a set of 4 of these to put in my 4-tire-at-once inflation system I put together for my HMMWV and using the Maxi Trax air compressor. Make sure you make sure these are all good before you walk off though. 1 of the 4 leaked air as i turned the handle. I had to tighten up the outside nut on the valve and then all was good. Check out the video I made on my channel. I replaced the check valves with these so that way all 4 tires balance themselves out with each other and end up with the exact same air pressure all the way around.
DavTech
2025-05-22 17:24:03
Bought a few different sizes of the same valve. Story is the same on all. Quality will be sufficient, but I wouldn't use this on anything that is detrimental (was planning on using them for the bottom drain on house water filter cartridges - NOPE, not happening). If these valves were around $1 each - they would be priced correctly. For this price, there are better models out there.Also, the body reads 1/4" on all the valves - which is confusing. I know what it means - it means it has a 1/4" opening, but when I am in a hurry and grab a barb valve, I will think that model would be the 1/4" barb.. Not very intuitive.
Nita
2025-03-01 12:08:17
These little valves were perfect for my fountain that had a little too much water flow from the pump. This valve enabled me to dial it back to just the right amount. Very handy!
Michael J.
2025-02-06 12:14:56
used as a shut off for gas to carburetor,works great!!
Brett A. Longmore
2025-01-29 14:05:45
Couple of these leak. A leaky valve is kind of useless.
Recommended Products