Your cart is empty.
Your cart is empty.Product Description
This 32mm and 36mmfan clutch removal tool kit can be used for removing water pump on models with temperature dependent viscosity drive fans.
Product Features
Premium Quality
This 32mm & 36mm fan clutch removal tool is constructed from premium high strength steel, which has strong hardness and not easy to be broken or bent.
Function
This 32mm and 36mmfan clutch removal tool kit can be used for removing water pump on models with temperature dependent viscosity drive fans.
Easy Operation
Place the wrench on fan clutch nut, and loosen the fan clutch nut by turning clockwise using 32 mm or 36 mm (both included) spanner to undo nut.
Two Sizes
The 32mm & 36mm fan clutch wrench removes lock nuts on temperature-dependent thermo-viscous fans, one wrench with two sizes make the work easier.
32mm & 36mm Fan Clutch Wrench Tool
How to Use
Step1: Attach the pulley holder bar with your bolts inserted through the holes, lock into place on water pump face.
Step2: Place wrench on fan clutch nut and loosen the fan clutch nut by turning clockwise using 32 mm and 36 mm spanner to undo nut.
Step3: If the hole sizes on the tool are smaller than the bolts holding the pulley wheel to the water pump, remove bolts and reinstall over bar.
Wide Application
The 32mm & 36mm fan clutch nut wrench can be used for removing lock nuts on the thermo-Viscous fans found on Ford, Mercedes many vehicles.
Customer
July 16, 2025
Works like a skinny wrench should!!!
CW
July 8, 2025
Fits 2002 dodge ram with Cummins fan. Worked fine.
Robert R.
June 19, 2025
Received quickly. DID THE THE JOB REQUIRED. I'd buy again.
Angela Lopez
April 27, 2025
comes in handy most combo sets do not have these 2 in the set
G TORIBIO
April 19, 2025
Removed fan from a 05 Dodge Ram 1500. You just have to wiggle it a bit to get it to fit on the 36mm side. A little tight but works great
gustavooh
March 30, 2025
nice
Jamie Maximus
February 25, 2025
I got this because I needed to change out the fan clutch and water pump on a 2000 Mercedes Benz ML 320. The 36 mm end fit. Great tool, better to have it on hand than trying to rent one or buying it locally. Well made.
Brian Eves
January 28, 2025
This is not 36mm!My 2005 ford f150 has a fan nut at 36mm!! I bought this to take it off. Nope! No way! Close but no cigar folks. It's 35mm
Recommended Products