Your cart is empty.
Your cart is empty.For mechanical pressure gauges (except fuel, nitrous, or brake pressure gauges). Includes 6 ft. of 1/8 copper line, 1/8 NPT Male to 1/8 compression fitting, 1/8 NPT Female to 1/8 compression fitting, grommet, and 1/8 NPT to 1/4 NPT bushing.
James Jenkins
2025-07-22 16:41:05
Works great to replace plastic hose
Rick
2025-07-19 14:45:05
Worked great for my oil gauge
shawn
2025-07-03 15:32:07
Good ðŸ‘
Eric Leendertsen
2025-06-19 16:55:35
I chose this over the clear plastic vinyl tubing for a couple reasons it's brass and will not melt like the plastic also less likely to rupture under year's of use
everton
2025-06-06 14:53:21
Good description, solid brass construction, fits well. Although there are cheaper brands out there, you can go wrong with anything Autometer ..
Eddie
2025-05-13 11:53:28
What I needed
Chris Miller
2025-05-04 13:27:49
Used this line to replace the plastic tube that came with my oil pressure gauge so I can have my vehicle on the track. I have noticed a sizable buzzing now coming from my gauge after using this. after some research I found that this is somewhat common since it provides a direct acoustical path that the plastic tubing did not provide. Make sure to put service loops in in both the engine compartment and the cab if your routing the gauge through the fire wall. This was a low cost option that was better than the poly tube that would meet track regulations. I am working on ordering parts and running stainless steel braided lines to remove this buzzing. Granted also being on full polyurethane bushings and aggressive built motor does not help either.
Jeff johnson
2025-04-07 12:00:06
Made well
Martin Lenneville
2025-04-04 12:03:04
Bonne etat
Rene
2025-02-19 14:54:15
used this on a Auto Meter oil pressure gauge for a tractor.I passed the pipe through a 1 foot rubber hose.flared each end then made 3 ring coils at each end of the pipe to cut even more on the vibration and tie wrapped.All went well works fine.
Terry Barkley
2025-02-16 14:36:49
This came with all the fittings needed to install. Very good product.
Old School Techie
2025-02-05 15:46:44
I bought this to use on an oil pressure gauge on a small diesel tractor. The problem I had was that the engine vibrates, especially at idle, putting stress on the tubing. Even though I left a coil of copper tubing between the engine and the frame, to try to absorb some of the vibration, the tubing would break off at the fitting on the engine, spraying oil everywhere. I ended up buying fuel injector hose at a auto supply store and just clamping it on, at the engine end, using a barb fitting. At the gauge, because of lack of space, I just clamped it on the threads. This method has given me no problems. If there was no or minimal vibration I am sure it would have worked well.
kenneth clarkson
2025-01-24 10:03:37
Item arrived on time and as described. We used this instead of the cheap plastic tubing that the gauges come with. This was installed on my sons Ranger that we supercharged
Recommended Products
