Your cart is empty.
Your cart is empty.No one enjoys scrubbing off stubborn, dried-up bug guts after a long road trip. That’s where the Bugflector II comes in. The high-profile wrap-around design provides maximum protection from all bugs, big and small, while its off-the-hood design allows for easy cleaning and waxing. Made from durable impact-resistant acrylic, the Bugflector II can stand up to everything from car washes and bugs to the wear and tear of daily driving or going off-road. Custom-molded to fit your vehicle’s exact year, make, and model and contoured to fit the curves of your hood. Available in dark smoke finish and proudly made in the USA with global materials
Larry Barton
2025-09-04 13:30:43
Very easy to install. Probably 10 minutes. Fits perfectly. Looks Great. Would definitely recommend this to anyone.
Kris Wolla
2025-09-01 11:52:39
Product was easy to install
Colorado Customizer
2025-08-25 13:52:45
This took about 5 seconds to install, looks, feels solid and professional, and is exactly what I was looking for.
Kenneth J. Wojnar
2025-08-22 17:30:00
The product is very good quality and perfectly patches the factory bolt pattern for hood mounting. Plastic is stiff but somewhat flexible and does not seem to bend at highway speeds. Includes rubber bumpers to guard against potential contact with upper hood surfaces (which does not seem to occur but good to have it there just-in-case) .Removal of old deflector and installation of new one took less than 10 minutes using simple socket.
Kevin Highland
2025-07-28 19:15:31
Very easy to install only took 5 minutes
HD Crabtree
2025-07-25 13:50:25
Installs into existing locations on the hood. Drilled center and added additional grommer and screw, as mentioned by others seems flimsy. The plastic (acrylic) is not the most resilient, it cracked when i grasped the hood to close it. Not amazons fault so no returns, drilled stress relief at crack end and ziptied the together.Gives a nice look to the truck with the window vents as well. Seems to increase air pressure on bottom side, hood lifts a bit more in the wind.
Hambone
2025-06-20 15:23:17
Perfect fit looks good it do not block view.
Darker-Side-Of-Blue
2025-05-20 21:45:49
Fantastic product at a great price. Easy to install. Requires no drilling. You just pop the 4 little plastic anchors into the square notches already in the hood, put four screws in there and you're done! I like the low profile look better than the the taller version on these trucks. Shipping was super fast, and while the box did have some damage to it, the product was well wrapped and kept safe.
Customer
2025-04-23 15:52:59
Bien fait
KSpar
2025-04-12 14:06:09
Fits perfectly, but it's a little pricey.
Gerry Vandenberg
2025-03-31 17:06:18
Upgrade
Cj
2025-03-12 15:15:49
Very quick and easy to install, the plastic clips all inserted very easily then were screwed into place within less than a few minutes.The plastic feels a bit flimsy but once attached it does make sense that it needs to move and wiggle on the front of the vehicle. It's currently mounted firmly on the front of my truck and it looks very nice. If I ever had to make another purchase for a different vehicle I would definitely buy one from here again, because the cheapest one I was able to find at a store was over $200, and this was only $90.- Would recommend.
DT
2025-01-18 15:26:11
Was able to use original holes from stock deflector. Great fit!
Recommended Products
