Your cart is empty.
Your cart is empty.Product Description
Vehicle Speed Sensor (VSS)
Brand information
SCHNECKE
- Provider of Vehicle Speed Sensor to the worldwide OEM market and aftermarket.
- SCHNECKE offers complete Vehicle Speed Sensor coverage for Asian, Domestic and European vehicles,
- Top brand awareness and unsurpassed quality.
Vehicle speed sensors are usually either inductive or optical sensors. The most common inductive sensors consist of a rod magnet on top of a magnetic pin that is surrounded by a fixed coil. This sensor is mounted a fixed distance from a ferromagnetic rotor with teeth. As the rotor turns and a tooth comes into the proximity of the rod, the magnetic flux in the coil changes. This change in flux results in a voltage pulse across the coil. The vehicle's engine control module counts these voltage pulses and computes the vehicle's speed. Optical sensors also generate pulses at a frequency corresponding to the rotor rotation, but instead of measuring magnetic flux, the optical sensor measures either reflected light or light allowed to pass through slits. When using an optical sensor the rotor either has light and dark marks for the optical sensor to detect the reflected light using photosensors, or a series of slits that allows light from an infrared source to pass through and be detected by a phototransistor on the other side.
- 1993-1998 Lexus ES300 V6 3.0L
- 2002-2003 Lexus ES300 V6 3.0L
- 2000-2001 Lexus ES300 V6 3.0L Input
- 1999-2001 Lexus ES300 V6 3.0L Output
- 2004-2006 Lexus ES330 V6 3.3L Input NEED QYT1
- 1999-2003 Lexus RX300 V6 3.0L NEED QYT2
- 2004-2007 Lexus RX330 V6 3.3L Black Input NEED QYT1
- 1992-1997 Lexus SC300 L6 3.0L NEED QYT1
- 2010 Pontiac Vibe L4 1.8L Input NEED QYT1
- 2007-2008 Pontiac Vibe L4 1.8L Input NEED QYT2
- 2007-2010 Pontiac Vibe L4 1.8L Input NEED QYT1
- 2003 Pontiac Vibe L4 1.8L Output NEED QYT2
- 2004-2005 Pontiac Vibe L4 1.8L Output NEED QYT1
- 2007-2008 Pontiac Vibe L4 1.8L Output NEED QYT2
- 2009-2010 Pontiac Vibe L4 1.8L Output NEED QYT1
Gus
2025-08-22 17:28:06
My engine light came on the code that came up was for a speed sensor I purchased this product and my car is running perfectly now. No more check engine light.
fran young
2025-07-23 14:12:17
Easy install fixed the shifting issue of a 2009 Scion XB. even 2 months later Thanks
Tori
2025-07-12 16:29:07
Fellow scion owners- I was throwing input and output codes- our vehicle has TWO speed sensors. One under the air filter, one under the battery housing. Make sure you've checked your vehicle before feeling disappointed! Replaced both and no more codes. All for $40, super super grateful!
Balu B
2025-05-18 10:07:41
2008 Sienna. It made the problem worse. Was getting a speed sensor P0717 signal. Replaced it with this. Not only did the error not go away, the gear shifts were erratic! Tried the Beck and Arnley. Problem solved. Vehicle hums!https://www.amazon.com/gp/aw/d/B09J5FWR2P?psc=1&ref=ppx_pop_mob_b_asin_title
Kyle
2025-04-28 21:49:03
I have a 2009 Toyota Sienna FWD and I got the P0717 trouble code, which indicates a bad transmission speed sensor. The van was shifting roughly and it was clear there was a need to change the sensor. I saw this sensor was much cheaper than anywhere else so I bought it.I installed it and tested, hoping the slight difference in the sensor end wouldn’t make a difference.I was wrong.Not only did it not fix the problem, but it shifted worse than before and was erratic. I pulled it back out, cleaned the OEM sensor with some mass air flow cleaner, then reinstalled that while I wait for the OEM replacement to get here.After doing further research, I found out this sensor is the second sensor, or the NT input sensor located under the battery. It is an exact replacement and so far, is working perfectly.Just be sure to double check your part numbers because they are near each other, but they are not the same.
Israel José Mendoza Fuentes
2025-02-26 14:55:09
Excelente producto. Elimino el código perfecto en mi Toyota Camry 2009.
Crumpler
2025-01-20 18:56:18
installed easily with the many Youtubes avaialble, on a 2006 Sienna. it is the front sensor, kinda under the battery , not the sensor near the starter. They are different be careful
Gary
2024-12-03 15:53:04
Ok I guess, not sure if it solve the problem or not.. it was a correct fits but who really knows… car runs, but I replaced many other parts at the same time.. I’m not say it’s bad, so if you need a knock sensor, but it via this company as they are a lot cheaper in price than an auto parts store.
Recommended Products