Your cart is empty.
Your cart is empty.Product Description
jerzgirl63
2025-08-11 14:50:06
Will be used on my HF station gear , seems to be a well made. Tested continuity was ok, tested resistance got a zero reading at 20ohm and 2000 ohm settings. Pins in center were centered correctly as was the female receptor, not like others reported loose pins. Haven't tested with any power through them yet but I only run 100 watts max. Looks like they'll be able to work out without deforming the insulators. I cant tell if these were a pressure fit center conductors or if it was soldered prior to encasing it in the housing, but it tested out ok. I would advise checking a few times after running them with low to average power to assure it doesn't develop an open condition due to that fact. I'm doubtful it could handle over 200 watts not knowing the construction design, and specs were posted.
Works
2025-07-17 11:01:29
Work very well. Very little losss downline.
D. Garrison
2025-06-22 14:55:19
Just needed a pair of these to complete an antenna project. Quality in fit/finish looks good. Built to last. On the tower now and have had no issues through several storms with these connectors.
Rick Carman
2025-06-09 11:55:02
needed a couple of 90 connectors for a couple of radios. works as designed. would recommend.
Ryan T
2025-06-06 10:07:14
Same to work okay
Bobby Raines
2025-04-07 14:57:13
Ok
Chase Haugh
2025-03-13 12:49:23
Fits perfectly on my GMRS unit to help with cable management, and you get 2 of them so I have a backup
CDawg
2025-03-12 13:15:17
Well made adapter that does the job for me.
ron ron
2025-03-06 16:04:35
ok
Andre Robitaille
2025-02-07 15:32:51
Aucun problème, #1
Terry
2025-01-22 16:21:47
I installed these on my coax. The SWR was off the scale. I tried matching the antenna but it didn't help. Took these off and the SWR is perfect. I took these out and then installed 1 at a time and the SWR was still high so I can only deduce that both of these are defective.
petera
2024-12-06 18:53:38
On the side where you suppose to attach the cable the depth of hole is to shallow. I had to file the Pl 239 cable pin little bit so the outer shell could touch "cogged" casing
Recommended Products
$6.20
$ 2 .99 $2.99