Your cart is empty.
Your cart is empty.High speed steel bits can be easily sharpened to a very fine edge for smooth, precise cuts. HSS bits work best with softwoods and light plastics. Single flute allows for faster feed rates.
KP
September 1, 2025
This bit cuts well. I'm cutting small grooves in MDF and Polycarbonate. If I keep the feed rate low I'm sure the bit will last a long time.
EL
August 29, 2025
I’ve only used once to cut through 1/8 inch deep on a cedar board and it worked really well even at a low speed. The diameter is actually a hair short to be 1/8 inch but it worked out perfect for me for very tight fit.
E. N. M.
August 28, 2025
Uses on Purple Heart wood. No issues with it like some others posted. I didn't use it a ton but it still seems sharp after my project. Good buy and cheap
Jessica C.
August 27, 2025
Needed to run a channel for my screen door to relocate the spline. This gave the perfect width, although using a handheld router my line was not very straight.Between this, a replacement doggie door flap and some wood I was able to add a doggie door to my standard screen door.
G. Raney
August 3, 2025
Recently used this in a Dewalt DWP611PK to route out a custom Jolly Roger in red oak for a brass inlay. Needed this to route out the smaller nooks and crannies (like his janky teeth).Depth was ~2.5mm and I ended up routing out a solid 10 square inches of material with this relatively quickly. I've had other router heads break off from heat and me going to fast, but this guy held up well to my abuse. Once I had the outline done I swapped out to a larger bit to remove the bulk of the wood to be inlaid.
Aviation Reader
August 2, 2025
Excellent for narrow work in both soft and hard wood
Sean S Lee
July 27, 2025
Great!
Average Joe
June 2, 2025
Working on a simple project with particle board and this broke less than half way into the project. I had only used it 6 times and the thing broke, even while doing progressively deeper passes to try and prolong the life of the bit.Total waste of money. Don't buy it.
Jose Luis Hernandez
April 3, 2025
Su corte es muy limpio
Cristina t.
March 30, 2025
Me gusto mucho
David Contreras
February 15, 2025
Excelente calidad de esta fresa tiene muy buen filo
Leonardo Navarro
December 7, 2024
De muy buena calidad y durabilidad.
Eleazar Alvarez
November 20, 2024
Le quedó perfecto a mi router Makita de 1/4, corte limpio y sin esfuerzo
Recommended Products
$32.99
$ 15 .99 $15.99
$20.40
$ 9 .99 $9.99