Your cart is empty.
Your cart is empty.
Package Included: 1 X Carburetor Kits as picture
Fits Part Number： 159064, 37-119, 3-304, 3-305,
List-1850, List-1850-1, List-1850-2, List-1850-3, List-1850-4, List-1850-5,
List-3310-2, List-3310-3, List-3310-4, List-3310-5, List-3310-6,
List-81850, List-80508, List-80508-1, List-83310, List-83310-1, List-83311, List-83312, List-R1850
MG
2025-08-18 12:00:55
I ordered this rebuild kit to replace gaskets in my 1979 Ford F250 4 barrel carburetor since it had been sitting in storage for over a decade and the carburetor would not allow the truck to start so it needed to be rebuilt. I found all of the gaskets to fit perfectly and every piece I needed was in this kit. I am not exactly certain on the model number but as far as I can find it is a version of the Holey 4160-C or 4180-C. I assume Ford had a special part number from Holley as I did not find the exact number when I tried to look it up. Either way the gaskets needed were in this kit and when finished the truck started and ran like new. I highly suggest anyone with a Holley 4 barrel carburetor give this kit a try it is not outrageously priced like many other kit seem to be and has all of the parts for several different Holley carburetors included. The gaskets are of equal quality as the original Holley gaskets but I did find one issue on one gasket, The punched out hole had a chad hanging as it was still in the hole but hanging half way out so it was easy to identify it should have been removed. A little poke and it fell right out so it was not a problem just if you are not paying attention it could have been installed and blocked the opening causing you big trouble. Look over all the gaskets before you assemble your carburetor just in-case. I had many gaskets left over since this fits multiple carburetors so don't worry about extras just use the ones you need. I highly recommend this kit for your rebuild as it is a good value kit with high quality gaskets and parts. Take your time and clean all your parts before reassembling the carburetor.
Alan Beal
2025-06-05 16:04:45
Â
Mr and Mrs CP
2025-03-08 21:18:22
Basic 4160 / 3310 carb kit. Coat the gaskets in chap stick and run it. Good kit for the price. Didn't run the power valve - but didn't see any issue with it either. Again- basic kit. No complaints.
Beau
2025-01-15 10:34:17
While you receive double gaskets for pretty much everything, the main reason i purchased this kit was for the accelerator pump parts. I ended up using a few other gaskets and tried to use the power valve. It was useless and just flooded the engine. I put my old valve in and I was off and running. Also with the carb i have, the idle mixture screws use a thick flat gasket while this only provides some sort of oring.
Stacy Ramirez
2024-11-13 13:24:50
My mechanic said never buy this part, poor quality no good
Recommended Products
