Your cart is empty.
Your cart is empty.
Fits for Husqvarna Chainsaw:
135 - Chainsaw, 140 - Chainsaw, 435 e - Chainsaw
435 e II-Chainsaw, 435 - Chainsaw (2008-05)
435 - Chainsaw (2009-02), 435 - Chainsaw (2011-05)
435 - Chainsaw (SN: 20081800001 - 20090400000)
435 - Chainsaw (SN: 20090400001 - 20102300000)
435 - Chainsaw (SN: 20102300001 - 20111800000)
440 e - Chainsaw (SN: 20102300001 - 20111800000)
440 e II - Chainsaw
Fits for Husqvarna Chainsaw:
Installtion guide:
Let the engine cool and disconnect the spark plug wire before installing this part. Wear work gloves to protect your hands.
1.Remove the nuts from the bar mounting bolts.
2.Rotate the chain tensioner screw counterclockwise to release tension from the chain, Remove the clutch cover assembly.
3.Install the new clutch cover assembly, Apply side pressure to the clutch cover assembly.
4.Using a long screwdriver, rotate the tensioner screw (in either direction) until the bar adjustment pin engages the hole on the bar. The entire assembly should snap into place when this occurs.
5.Once the adjustment pin engages the bar; rotate the tensioner screw in the opposite direction until the chain begins to tension.
6.Install and hand-tighten the bar nuts.
7.Grasp and raise the distant end of the bar and chain assembly (opposite the engine) until the saw begins to rise. Grasp the chain at the center (and top) of the bar.
8.Lift the chain away from the bar assembly and inspect the gap between the two components. The chain is tensioned correctly when the weight of the chain does not cause it to sag below the guide bar.
9.Rotate the tensioner screw (as necessary) to tighten or loosen the chain until it is correctly tensioned.
westley s white
2025-05-28 20:44:18
Worked on my jonsredCs2238,mint
Pavel Kalashnikov
2025-04-03 17:42:02
Easy installPerfect fits Husqvarna Chainsaw 435, It takes only 10 minutes to complete the replacement of the chainsaw cover according to the installation instructions. For the less familiar this is very easy to install.
Nick Krebs
2025-02-10 17:03:36
This cover is made of high quality high carbon steel and anti-rust coating, can be used in rain, snow and other harsh weather. Durable and helpful for my logging.
Recommended Products
$25.90
$ 11 .99 $11.99