Your cart is empty.
Your cart is empty.Product Description
Universal 3 Inch Car Cold Air Intake Kit Pipe Kit
Designed for increasing engine power
Improve the power and torsion power
Reduce noise of the engine
Feature
Estimated horsepower gain of 10.68 HP at 5341 RP
High quality and efficient air intake system
Intake hose can washable and reusable
Tube made of high quality aluminum
New and high quality
Installation Guide
Make sure your engine is cool
Disconnect your battery cable from the negative
Remove your old air intake
Attach the silicone coupling to the throttle body
Secure the coupling by tightening a hose clamp at the end
Place another hose clamp on the front of the coupling
Slide the intake tube into the silicone coupling
Tighten the silicone coupling and secure all brackets on the tube
Plug the mass air flow sensor into the new cold air intake system
Reconnect the battery and wait
Packing Included
1 x Car cold intake pipe
1 x Silicone joiner
2 x Hose clamp
1 x Tube hose
1 x Mounting bracket
Christian
2025-09-02 13:09:36
The media could not be loaded.
Christopher
2025-08-22 16:52:29
It is a great air intake for the price. I had to buy a different coupler and clamp for it because it came with a 3 to 2 1/2 inch and I needed a 3 to 3 inch, but that's not a problem. I also wish that the "blue tube" for vacuum line was longer it barely fit my car. I might end up buying a longer one.It have my car a great thoaty sound that and added a bit of power and improved gas mileage.
Thor
2025-08-03 16:19:06
Works great for my application I would purchase again
VladaZ
2025-07-29 12:10:11
Works fine on Ram 1500 2018 V6. You will need few little adjustments. You will need 3" Spectre Intake Coupler- around 12$ to connect aluminum tube to throttle body. And then you can connect breather hose, or what I did connected little breather filter,like that hot vaporizing air is not returning in throttle body. There is no hole for temperature sensor, you can drill hole and push it in aluminum tube. I left it outside very close to a tube. Bracket who holds filter is screwed two, see pictures.No codes, parts are quality and works fine. Engine will be louder when you accelerate, if you maintain speed engine is quite as with stock filter. This V6 performance engine absolutely need this kind of filter, stock filter was trapping a lot of heat.
Jerry Johnson
2025-07-23 13:48:10
Had to do some retro fitting, wasn’t able to use the main pipe it came with luckily AutoZone sells parts and I was able to make the filter work
fishingdad
2025-05-20 11:10:54
Going into a project, should work and look good.
Ben M
2025-04-27 13:57:37
Great looking product, but as I was putting it in place I noticed there were a additional hoses that needed to be hooked up (the sensor line) and there wasn't a spot for it.Need to be sure that the vehicle can operate properly without this attachments or you'll be getting error messages on your dashboard.
Ben Kerber
2025-02-19 18:24:35
Had to stretch and modify to fit my 07 Cadillac Srx, made it work but far from universal
Recommended Products
$190.00
$ 75 .99 $75.99