Your cart is empty.
Your cart is empty.- Fits most 9” Band Saws that use a 62” blade including Powertec BS900, Performax BS900PM, Central Machinery 60500, Craftsman 3299 / BA230 - Made of Premium Carbon Steel - For use in Soft and Hard Woods, Plastic and Non-Ferrous Metal
nick
2025-08-15 10:34:51
It works well with my central machinery 9 inch bandsaw
The Prodigal Carpenter
2025-08-08 18:46:19
This 62", 6TPI, 1/2" width bandsaw blade fit my 9" Harbor Freight bandsaw perfectly. I cut primarily hardwoods as I needed a blade that wouldn't constantly bog down in my less than premium saw, and this blade nailed it.Started by cutting 2" pieces of Brazilian Walnut (aka IPE), some of the hardest wood on the planet; as I took old wood flooring and turn them into beautiful kitchen spatulas.Can't tell you how many typical 14 TPI blades I've labored through over the years, but this was like finding a diamond in the rough. Undoubtably 5 star
Frank
2025-07-11 11:33:30
Use it on my Harbor Freight light weight Bandsaw. No issues
Joe Ralle
2025-05-19 14:50:53
They work as good as the expensive ones
Richard L Harding
2025-03-20 13:03:34
I cannot believe how dull this blade is. I could barely scratch the surface of some steel that I was trying to cut.
michael crump
2025-01-19 18:58:53
I was gonna toss the saw out. After a lot of F-&#ed up wood with blades that twisted and ruddered in the wood that were too thin. I was done. But I noticed that the rollers on the guides weren't adjustable. The blades I had were too thin in the rollers. .014 etc. Then I found this. .025 with 1/2 inch width, the teeth cleared the rollers and it fit tightly on both top and bottom. Wide enough kerf. By hand, the blade don't twist in the rollers, they hold and engage the blade properly. Cleaned and oiled the bearings. Just like a brand new bandsaw with the proper blade like from the factory. I'm glad I ordered two, just in case one pops. I can now use my fence and shove thick wood through it with confidence. 3/4 inch birch plywood, 5/8 inch MDF, no problem. Nice & strait. Don't even have to sand much. Will still use it to build me a table saw anyway. I do know not to run the saw at higher speeds now. Should be advertised as for this type of band saw. As a factory replacement. Them other thin ones are no good. Much cheaper than having one custom made for $43 bucks. Thanks for giving this woodworker strait cuts again. Happy customer.
Randy
2024-11-27 18:50:41
Great for wood but didn’t cut metal as avertised. I even wondered if l was sent the wrong blade. Ordered a variety of blades for wood and ferrous metals. They all looked alike. Didn’t cut the angle iron whatsoever. For wood they all did great.
teresa holley
2024-11-23 15:13:27
Very curteous company great service and very prompt delivery it fits perfectly will definitely be ordering from them again very happy with my purchase!
Recommended Products
$20.57
$ 10 .99 $10.99