Your cart is empty.
Your cart is empty.Product Description
Package Included: 1 x Stepper Motor
Specifications:
Motor Type: 2 phase 4 wire
Drive Voltage: DC 5V-12V / 100-800mA (the higher the voltage, the greater the force and the greater the heat)
Step Angle: 18 degrees
Phase Resistance: 15.5Ohm
Lead Screws Length: 90mm / 3.5"
Lead Screws Diameter: 3mm / 0.1"
Slider Width: 15mm / 0.6"
Effective Stroke: 80mm / 3.1"
Screw Pitch: 0.5mm / 0.02"
Stage Size: 105 x 15 X 25 mm / 4.31" x 0.59" x 0.98"
The speed of a straight line is the maximum 25mm/s
Micro Sliding table fit for DIY laser engraving machine as its XY axis
Wiring: Blue A +, Black A-, Red B +, Yellow B-
Note that: The stepper motor, direct power is not rotating, it need to stepper motor driver board, Search: B09BTWQPTB.
Tips: If DIY engraving machine, you need to modify the slider by yourself, the default slider does not use linear bearings, so the accuracy is generally unstable.
Russell Pool
2025-08-06 15:02:33
Works great.
Aaron Brown
2025-05-15 14:43:20
The media could not be loaded.
stu
2025-01-30 10:32:17
Two caviats: Although the specs say 5 to 12 volts, it seems to run happiest at 5 vdc. At 12 vdc, the motor gets scary hot. Motor max rpm is not specified, but I found running it over 1500 rpm it tends to lose pulse counts and "drift" one direction or the other. Still, at 1000 rpm it should be plenty fast accurate enough for most projects, and I think it will do just fine for mine.
raybug2
2024-11-13 11:09:42
Too small for my project.
Recommended Products