Your cart is empty.
Your cart is empty.Ultra Sheath MA - 1-1/4" ID x 3ft.
J. Ronald
2025-07-11 15:59:16
Using this not as intended - The collector for header #1 came within half an inch of the 2" Radiator return hose. Wrapped the header which reduced the air gap and used a 9" section of this sheathing to cover the hose (they don't have this in 2" unfortunately). The sheathing is great, piping stays cool on the other side. The stitching came out easily once cut, without damaging the sheathing.The sheathing has stayed together well on the car well the last 2 months. Right behind the rad fans, and it hasn't frayed or separated.
timothy j tambert
2025-06-19 16:24:23
good
Trevor Ritch
2025-05-24 11:54:52
Extremely fragile, by the time I tucked two hoses into it and router it the end we’re frayed about 1/4†on both sides and there are multiple places it’s delaminating in the center.. (I did not make any cuts to the material) the factory edges have nothing holding them together
Boneyfinger
2025-05-05 12:20:33
Nice producte
Big Dawg
2025-02-11 16:51:38
Great product but it pulls apart easily at the ends. Pull from the center to slide and adjust sleeve. IT'S AMERICAN MADE ðŸ‘ðŸ‘ðŸ‘ðŸ‘ðŸ‘ðŸ‘ðŸ‘ðŸ‘
29blue2001
2025-01-28 11:37:48
Cheap material, rip's easily
Leo Pelsh
2025-01-23 16:28:37
Used this on a car block heater cord was large around the cord but is good so far keeping cord protected from hot engine. Would like to see it available in smaller size and optional mounting ties that can take the heat.
Recommended Products
