Your cart is empty.
Your cart is empty.Product Description
Ace
2025-08-31 13:58:15
Awesome product for the price, ngl i was a little skeptical but after receiving them and installing them- Im glad i purchased , make your vette look lower and wider, awesome upgrade for the price
Holloway L
2025-08-07 12:27:17
Good product for the price. Finish is good, fits well. You will need to install with self starting screws and double sided tape NOT SUPPLIED. Screws are supplied but I didn't get any in my package. Overall happy, looks good.2015 C7 Z51.
Rubi10a
2025-05-05 11:06:03
The side skirts are good value and look great. I was initially sent 2 passenger side pieces and had to do return and reorder but it worked out okay. I installed with black rivets and used black caulk instead of double sided tape. Look great and happy with.
Frank Bianco
2025-01-27 17:40:35
Was not even close to fitting my corvette.
JOHN THEOFILES
2025-01-07 18:33:32
Replacement trim for some I famaged
Dr Mark
2024-12-26 11:50:07
Installation was fairly simple. Remove the existing screw just behind the front tire (there are several to look at, only one is the correct one) . I attached the front end first, but kept the screw loose. Then I went about half way back from the front, and attached that screw, being sure to press the panel right up to where it should be, before you attempt to install that screw. Then I went to the last screw, just in front of the rear tire. SCREWS ARE SELP TAPPING, NO NEED TO PREDRILL HOLES IN BODY. CAUTION: I DID NOT FINISH TIGHTENING EACH SCREW WITH THE POWER DRILL AS THAT COULD BE TOO MUCH FORCE, AND STRIP OUT THE HOLE YOU MAKE IN THE BODY PANEL. FINISH TIGHTENING WITH A PHILLIPS SCREW DRIVE, BY HAND. After these first 3 screws, the panel is now in place to install the rest of the screws. There is quite a distance between the 1st and second screws, so I added one addition screw half way between the first two. Really adds a classy look, and functionality to your c7. Sides of the c7 do not get as dirty after a drive....... sweet!
Derk
2024-12-02 18:52:06
I will try to remember to post pictures once I am done... but I love them for the price! get them! company is amazing to work it as well!
Mike F
2024-11-22 14:51:26
The skirts were better than I was expecting. The color matched the existing rear spoiler perfectly, so looks factory. Watched a utube video for installation which was helpful. Bought 3M Automobile 2-sided tape (not included). Did the install in my driveway in a half hour without lifting the car. There is only 1 bolt that is used from the car, the rest are self taper screws that are included. Pre-drilled holes are a help, but added 1 additional screw toward the front under the fender side vent. I was a little apprehensive screwing holes into my Baby, but the hole are down in the rocker panel out of sight. To install you must start with the front bolt to then line up the rest of the skirt. Then push skirt into place, 2 sided tape holds it as you screw it in. Again utube video was worth a watch to avoid mistakes. Once installed, very solid and looks amazing. Sets my car apart from the other C7 Z51's. High recommended. I also added new front splitter to complete the look. 🇺🇸
Recommended Products
$170.00
$ 67 .99 $67.99