Your cart is empty.
Your cart is empty.Exedy Master Cylinder - MC553
William D. Daugherty III
2025-08-17 11:34:24
Not easy to install! It took me about an hour by myself. 30 minutes with a friend. Removed it to see if bench bleeding would speed up the process.... it didn't. Must use some sort of bleeding kit, or better yet have a friend with lots of time on your hands, because it took almost 30 minutes to bleed the air out of the lines once installed. Push pedal down, open bleeder for half a second, close bleeder, release pedal. Repeat about 100 times before we finally got the air out even after bench bleeding.
Andy P. Phan
2025-08-01 14:01:57
This is a great replacement for your OEM CMC and the price is more than fair. If you have anything other than a stock clutch, YOU NEED TO buy a CMC WITHOUT the triangular plate as the OEM ones cannot handle it. This will fix your gear grinds. You also may or may not have to fix your clutch pedal height depending on your situation.Quick and easy install if you are mechanically inclined.
Don Power
2025-06-22 10:31:25
the clutch master has not failed so far.REUSE THE OLD PEDAL LINKAGE INSTEAD OF THE EXCEDY ONE, AND You may wish to purchase the following part number from Honda prior to tackling this project: 46942-S5A-003.you can pull the flare nut pin out using a 4 ft long flathead and have it spring out to some random place in the engine, or you can use 2 normal sized wrenches to loosen the two.
Akino757
2025-06-17 14:31:08
Bolts right on..
Chester Lee
2025-03-22 21:59:41
Too much play in the pedal even I adjust it to the max.
Rose Van Camp
2025-03-14 11:20:14
This does NOT include the bushing connector piece and pin for the hydraulic line to screw into. You will have to remove the U pin and piece from your old one. Kind of chincy if you ask me. -1 star. Also the bracket piece that connects the master cylinder to the clutch pedal was too big, again had to use my old one, or possibly could have bent it closed more, but -1 star for that. So 3 stars, but it does work so far. On a 2005 Honda Civic EX, I also replaced the slave cylinder with the same brand.Update: Master cylinder went bad, December 23 2021, so got a good 7 months out of it. Sad. Go with another brand.
Wayne J.
2025-01-20 11:29:10
Replaced leaking oem master cylinder and so far it’s holding up
Ashley
2024-11-16 16:56:46
Used this to delete the delay valve in my 06 v6 6 speed accord. Night and day difference and it was 100% bolt in!
Recommended Products
