Your cart is empty.
Your cart is empty. FITMENT NOTES
- Will NOT fit Vortec engines
TECH SPECS
Header Type.........................Short Tube / Shorty
Primaries Diameter...............1-1/2 in. (38mm)
Collector Diameter................2-5/8 in. (67mm)
Head Flange Thickness........7/16 in. (11.5mm)
Pipe Thickness.....................16-gauge (1.5mm)
Material.................................Mild Steel
Finish..................................Black Paint
Tristan p.
2025-08-27 15:19:01
1993 k2500 Perfect fit, seals great, might have some issues sealing 100% to y pipe but that's as easy as a donut gasket. 5/5 stars. Did a head gasket change on my truck and these headers woke it up monumental. Worth the money, easy install, note that the back spark plugs are hard to get to now but it's worth the power gain and sound. Great welds, thick flanges. I recommend using the gaskets for your heads and not the headers as they might not seal right. I used felpros. Fits factory y pipe, the paint ain't too great heat wise but better than rusty restrictions from stock exhaust. 10/10 would recommend. Arrived early and installed easily. If you are deciding these for your sbc 350, go for it. It's a hassle but worth the effort. I also had to do a whole engine teardown on top lol.
john rogers
2025-06-19 14:46:39
Used them on my son's 1994 350 Chevy pickup and bolted on easily and fit great. Would highly recommend
David H.
2025-04-18 10:15:46
Sounds good. Breathes good. Looked good for a second until the paint peeled off and blew away immediately after firing up for the first time after installation. Still a pretty solid deal.
Mike c.
2025-04-15 13:02:50
These headers make my built Chevy 350 sound great! Also look awesome!
Chris
2025-02-04 11:19:40
Fits 89 OBS great, coating is not very heat resistant though, wish I would have known prior to install, will probably end up wrapping
James
2025-01-19 14:32:35
I don’t honestly know how to review this because I don’t know if the header was warped or if the head on my truck was warped but it took four gaskets to get one side to seal. Either way that’s was the only issue.. I do like the quality of these headers the flange is thick welds are good and they made my little 350 sound good and woke it up just a little. Pro tip remove the finish and paint with high temp paint before installing.
Sucely
2025-01-02 10:37:08
Amazing quality headers. Thick mounting flanges with all the hardware to install. Only issue is that the spark plugs don’t have any room to be replaced. This is for aftermarket angled heads so see what’s the factory orientation and go with that.
Recommended Products
$149.99
$ 61 .99 $61.99
$119.89
$ 49 .99 $49.99