Your cart is empty.
Your cart is empty.With over 25 years of experience in aftermarket suspension design. State of the art software, fabrication equipment along with our seasoned engineers and fabricators allow the company to develop products that are constantly on the cutting edge. Fabtech leads the industry with extensive research, design technology and rigorous testing that results in the highest performing, finest quality suspension system for the discerning offroad enthusiast
Speed
2025-09-01 20:35:00
I'm running a 6" FabTech kit on an 02 Avalanche. These directly replaced my originals which finally took enough abuse after 18 years, that I snapped a mounting screw on one side.A single order comes with one (1) end link, about 9in. in length, four (4) thick rubber bushings, two (2) end caps that act as washers, and the two (2) screws/bolts that hold it all together, using a 5/16 hex key.If you need to swap out both driver and passenger sides, YOU WILL NEED TO BUY TWO KITS. I recommend using anti-seize on the bolts to help keep them from getting jammed too badly over time.Overall a good quality item and although they will probably tarnish as my originals did, the bolt will break long before the end links. I'm rough on my trucks, so if this product could last me nearly 20 years of off road use and abuse before snapping a single bolt... I have total confidence in them.
Nate
2025-07-24 11:15:03
I emailed Fabtech asking for the part number which they replied within five minutes. I have a 2002 Chevy Silverado 1500 4WD with a 6" Fabtech lift. My original end link rusted and busted which I had to use a sawzall to cut the top bolt off. Took a couple minutes to put it on with no problems. I do want to spray these with rhino liner or something to protect from the all the salt on the PA roads. My only gripe is the hex bolts but that's minor. Some quick tips... the ridges or lips on the bushings goes into the control arm and into the sway arm. Keep your wheels straight. I sat a bottle jack on the control arm and raised the sway a little to get the bolts started.Great product minus the soon the be rust factor.
Fit Perfectly!
2025-07-01 15:02:58
Fit Great! They were used on the Front End of my truck
sean t farrell
2025-06-17 10:09:59
when I open the package, I noticed I was missing two rubber bushings which i need so my sway bars will not smush.
Paul Soto
2025-03-21 15:54:32
Went to replace these today opened the box and I’m missing two bushings and two washers
Customer
2025-03-19 17:14:13
Good strong product, exactly the part I needed, 04 Chevy Avalanche (6" lift) will fit all half ton Chevys from that generation. I advise paint or sealing the metal some how to keep it from corroding, that's the reason I'm replacing.
Daniel M
2025-03-02 18:32:20
The parts were just as described, came with hardware and fit great! Very happy with on the order. Just make sure to reference part #.
Trevor
2024-12-22 12:06:58
Perfect fit for my 03 Chevy Avalanche 5.3 with 6†fab lift!
Recommended Products
