Your cart is empty.
Your cart is empty.FelPro gaskets offer 100% vehicle sealing with applicationspecific materials to give you sealing solutions with the performance and durability professionals trust
David T Whiting
2025-09-05 16:21:07
Nice gaskets. Seemed to be good quality and fit nicely. The bolt grommets slide on relatively easily (I didn’t have to use a socket to help push them on) which saved time and effort. I installed these last week and no leaking.
EliminatorBB
2025-08-29 20:24:36
Fits Great like OEM Acura items.
Bella Rose
2025-07-26 10:36:55
If you’re hear, you’re a DIYer.The removal of those old spark plugs seals is going to be the most challenging part of this project. There are many YouTube videos showing how to punch it out with a screwdriver and such. DON’T!!!!Most valve covers are aluminum and not steel and CAN get chipped and marked with the tool thus compromise the seal on the replacement. Try to pry up the old seals by leverage instead, less chance of making any mistakes and leaving any marks.I only found out about this because my back cover was leaking. And when also replacing the front cover as one job I found out that the front spark plugs seals was dented from a previous valve gaskets replacement from a repair shop about 3 years back. There were tool marks that caused my spark plugs tubes to be flooded (2 tubes out of 3) over times.Best of luck folks…..hey if crew up. They also sell the valve cover separately here on Amazon because that what I ended up doing. LOL.
The BLUF Reviewer
2025-07-24 11:57:56
This gasket kit has held up amazing! No leaks whatsoever after almost 18 months on the car. Perfect for outside the box. While it can be a pain in the rear to install new valve cover gaskets on the accord, it’s worth it!
Goonies LLC
2025-07-23 18:46:28
Fits on an 09 Odyssey Touring. Make sure surfaces are cleaned prior to installing the new gasket set. Since you are pulling off the manifold. Order a manifold gasket too.
April Mikolowski
2025-06-28 11:20:18
These are perfect and fit great. Make sure to be very cautious when prying out the old spark tube seals from the valve cover. I used an 18" pry bar and they came out relatively easy. When installing the new spark tube seals I used a large rubber mallet/ deadblow. I simply gave them some gentle love taps an they went right in. Definitely lubricate the seals and the spark tube with fresh engine oil before forcing them on or you will cut them and have leaks.... Ask me how I know that...For the valve cover bolts I snipped off the old seals, put them in a vice, and used a socket and hammer to bump them on and it worked great.Also check the valve cover for wear around the tube seals. My front valve cover looked good on the outside, but the inside had completely deteriorated until it was paper thin. Had to replace that too.
hemant patel
2025-06-13 19:15:54
Worked great!
Mr.T
2025-04-23 12:52:38
Had a 2010 honda pilot with misfires from plug well filling up with oil from bad gasket. With this kit and some cursing and praying, I was able to fix vehicle and get it back on the road.
Oscar Tepepa Sanchez
2025-03-05 16:45:52
Buen producto, cumple las espectativas de calidad
Flavio Gustavo villalba
2025-02-13 11:50:12
Falta de partes en el paquete
Recommended Products
