Your cart is empty.
Your cart is empty.The general purpose ultrasonic level transmitter provides continuous level measurement up to 49.2" (1.25m) with a 4-20 mA signal output, and is configured via our free Webcal software. The embedded level controller can lower cost by replacing external control hardware. This non-contact liquid level sensor is ideally suited for corrosive, sticky or dirty liquids, and is widely selected for small day tank, skid, IBC, sump and process tank level applications. Range: 49.2" (1.25m). Accuracy: 0.125" (3mm). Resolution: 0.019" (0.5mm). Dead band: 2" (5cm). Beam width: 2" (5cm). Configuration: WebCal PC Windows USB 2.0. Memory: Non-volatile. Supply voltage: 24 VDC (loop). Consumption: 0.5W. Loop resist.: 400O maximum. Signal output: 4-20 mA, two-wire. Signal invert: 4-20 mA or 20-4 mA. Signal fail-safe: 4 mA, 20 mA, 21 mA,22 mA or hold last. Contact type: (4) SPST relays. Contact rating: 60 VA, 1A maximum. Contact fail-safe: Power loss: Hold last. Power on: Open, close or hold last. Hysteresis: Selectable. Process temperature: F: 20 to 140 degree C: -7 to 60 degreee. Temperature comp.: Automatic. Ambient temperature: F: -31 to 140 degree C: -35 to 60 degree .Pressure: MWP = 30 PSI (2 bar). Enclosure rating: Type 6P, encapsulated,corrosion resistant and submersible. Enclosure material: Polycarbonate. Strain relief material: santoprene. Trans. material: PVDF. Cable jacket material: Polyurethane. Cable type: 9-conductor, shielded. Cable length: 48" (1.2m). Process mount: 1" NPT. Mount gasket: Viton Classification: General purpose. Compliance: CE, RoHS. Approvals: cFMus. Four (4) programmable relays rated at 1A/60VA for switch, pump or valve control and fail-safety, 1 pump or valve with 3 alarms, 2 pumps (lead-lag) with 2 alarms, 2 pumps (duplexing) with 2 alarms, 4 independent switch point alarms.
JECII
2025-08-25 10:00:47
Useful sensing device .. support has been excellent. Documentation could use some clarification but product operates well and will be a useful addition to process monitoring.
akml
2025-05-31 12:53:02
I bought this sensor to measure the level of product in small tank . The setup software is great but The product performance was not good .If the product level change fast the transmitter become hanging and the output become fixed for about 1 min to return to read again .
Brennen Gagnon
2025-02-09 18:11:44
Constantly jumps around, readings are never constant, seems to be faulty
Recommended Products
