Your cart is empty.
Your cart is empty.Product Description
Fogland misting nozzle adopts all stainless steel structure, which has stronger corrosion resistance, prolongs nozzle life and reduces your use cost
Brass misting nozzles are easily corroded and rusted by water after being used for some time
Stainless steel nozzle has stronger corrosion resistance, prolongs the use time and reduces your overall cost
Stainless steel misting nozzles has smaller droplets and stronger cooling ability wtih smaller flow rates but less water consumption
Brass misting nozzles has coarser mist and poor consistency of spray performance
Stainless steel misting nozzle 0.024" orifice, effective atomization, suitable for large-scale atomization and cooling in greenhouses, gardens, courtyards, etc.
Misting nozzles are standard threaded 10-24 UNC, suitable as replacement nozzles for most misting cooling systems.
Working parameters of the stainless steel misting nozzle can be used under the pressure of tap water, which is easy to use and easy to operate.
Danny L Lane
2025-09-02 12:43:01
These nozzles work must better than those with just a hole inn nozzle! . They really produce a fog versus the other types. .
Chester Shipman
2025-07-21 14:37:48
Much better than the cheap brass ones that came with my misting set up originally. I use it to water the plants in my greenhouse. They’re easy to install, and serviceable too so I’m hoping they will last with minimal parts. The spray pattern is fine and consistent, they are exactly what I was looking for.
farmer
2025-07-12 11:44:28
The media could not be loaded.
Robert A. Costanzo
2025-06-30 13:59:41
Easy installation
Billy
2025-05-03 16:18:32
I bought the 0.4mm stainless misting nozzles. These are much better than the less expensive brass nozzles. Yes, these cost more but I think they are worth the difference.Even with filters on the water line, the 0.4mm brass nozzles would only mist in a nice even cone for a few hours and after a few days (5-7) they would either stop spraying or the water would come out in a steam instead of a mist. I got tired of replacing brass ones and soaking them in vinegar or CLR. Then, I switched to simply replacing clogged brass ones and throwing them away.These stainless steel ones have been installed for over a week, are used 4-5 hours every day, and they still mist perfectly.I am sad to report that I might not need to be a repeat customer! ;)I will recommend very highly, though.
Paul Kuntz
2025-02-27 15:45:32
I personally installed a PVC misting system. I used copper misting nozzles that came with the PVC "T". These clogg easy and often. This upgrade is as one would find at a outdoor professional business venue! My strongest recommendation as a plumber and DIY guy!
Ryan
2025-02-25 10:30:00
Ah-ha! Finally! A nozzle worth buying. They are a 2 piece design so you can take them apart to clean them. The mist they put out is very fine and is a good amount. So glad to have come across these. Pretty sure the brass ones and the other stainless ones I have are going straight in the trash now.
D. Boles
2024-11-21 12:27:08
I got these to replace some one piece nozzles that were always clogging. These work perfectly and if a nozzle does get clogged or the spray flow is reduced, it's super easy to disassembly and clean. Highly recommend these!
Recommended Products