Your cart is empty.
Your cart is empty.Product Description
Installation
This is a two-piece design, the upper and lower halves are held together with the middle bolt, and then the bracket is secured to the car with the remaining 4 bolts. You can remove the top half of the bracket, which gives you enough room to install or remove the wiring, then you just bolt it together and reinstall the car bracket bolts.(This will not fit any car, fabrication is required).
Fire Wall Pass-Through Bracket
For Holley Terminator X Max
The firewall pass-through bracket is made of aluminum-aluminum alloy processing, with an anodized surface and precision polished. The trial bracket is more durable and corrosion-resistant.
Base Plate
Installation requires the base plate to be fixed first, followed by the wiring harness through the reassembly panel.
Unique Design
The arc-shaped design of the wire harness holes on the firewall pass-through bracket minimizes the damage caused by friction to the wire harnesses, which will not harm the wire harnesses even after prolonged use.
Neatly
Enables the wire harness to be placed more neatly and held firmly in place.
Doc McCrary
2025-09-06 16:34:15
This is by far the best piece to use when looking for a pass-through. This, in my opinion, is better than the other pieces I ordered because it sandwiches the thin firewall sheet metal on either side and also protects the wires. It also looks better as a finished product and the tight clearance to install is easier. Stay safe and be kind.
Clyde Davis III
2025-08-24 18:53:21
It was hard to find a flat surface for the piece but worked out great in the center
Ronald Bibey
2025-04-30 18:46:04
As described, great product.
A stretch
2025-04-22 12:16:06
Seem to be a great bulk head plate. I didn't like the anodized silver so I striped it and polished it and I didn't like how your supposed to mount both plates on top of each other so I manage to mount though the fire wall just using the center 6 bolts to sandwich the plates between the firewall.
Stcgf
2025-03-25 14:37:39
Input out put wires wont fit with harness. Its made well, cheap chineese screws tho. Just so so.
LS Truck guy
2025-03-04 17:11:06
The part itself looks great! The machining and tumbled finish looks really nice. But WHY did they not put the bolts in a separate bag?!The bolts were just tossed in the bag along with the part left to mar up the part.
DAN ROCKSTAR
2025-02-19 18:51:43
THIS PLATE SANDWICHED THE FIREWALL AND IT LOOKS LIKE YOU THINK IT SHOULD BE. THANKS
Cory
2024-12-29 17:25:57
Missing 2 mounting bolts and little scratched up
Daniel
2024-12-09 10:39:55
Worked great with my terminator x max harness. Had room to fit transmission and drive by wire harness threw aswell as the engine harness! Definitely recomend for anyone installing a terminator x
Recommended Products