Your cart is empty.
Your cart is empty. Fitment Information:
- Pump Gear Pulley Tool for 1988-2012 Dodge Cummins 5.9L/6.7L
-This will work on any 12 Valve 5.9 CUMMINS Turbo Diesel with a VE style Injection pump. D/W 250 or 350
- Also works on ISL9. Work better than T-puller.
Features:
- High quality bolts and steel.
- Increase speed and efficiency.
- Good outfit to deal with.
Lee
August 31, 2025
I’m a diesel tech and work on a lot of Cummins and this puller has held up great. I haven’t had an issue yet with it. I also like that the holes are slotted and work on most pump applications. The thin design and step work well I’d recommend it to anyone to buy.
Chris Pruett
August 16, 2025
Removing the injector lines and the injector pump is hard enough, you don’t need sub quality parts to add to your misery. With this tool, not only was it a perfect fit for my 2nd gen Cummins, but it was also compact enough where removing the radiator and shroud wasn’t necessary. Why pay top dollar for a tool you’ll likely use once, maybe twice, in the lifetime of your Cummins? I highly recommend buying this today as you never know when that injector pump will quit.
CS Service
August 13, 2025
Very basic good tool for pulling pump gears off of the shaft.
Guadalupe g. Lozano
July 25, 2025
Good product
Doyen
July 7, 2025
I recommend it as a solid tool, it works.
Ron King
April 26, 2025
Did the job to remove pulley with limited room.
Wayne linder
April 7, 2025
Used several times now with out issue
Raven
February 28, 2025
This tool is pretty minimal at best. The shoulder/body of the tool should be thicker. Also, depending on how far down you screw the bolts, you can easily damage your engine gear cover. Replacing this cover is pretty major work. As a minimum the tool should come with instructions and cautions...
Don Mann
January 17, 2025
Worked as was designed. Good buy
Recommended Products
