Your cart is empty.
Your cart is empty.Product Description
Our PVC Hose
PVC Hose Comp Chart
| | MADE In the USA | |
| | High Quality PVC | |
| | Reinforced Coils | |
| | Groundable | |
| | MADE In the USA | |
| | High Quality PVC | |
| | Reinforced Coils | |
| | Groundable |
| | MADE In the USA | |
| | High Quality PVC | |
| | Reinforced Coils | |
| | Groundable |
| | MADE In the USA | |
| | High Quality PVC | |
| | Reinforced Coils | |
| | Groundable |
- PT PVC Hose
- LST PVC Hose
- HM PVC Hose
- Standard PVC Hose
Donald Priest
2025-07-13 17:05:47
Works great for my lawn vac
Dave
2025-07-03 10:27:48
I used this for a commercial leaf vacuum. The tube is softer than the original. It shrinks up under pressure, when there’s a jam. It was used for several hours so far 2024 season and it’s all good. No holes, it’s lighter and more flexible than the original. Hopefully it lasts.
P. Bucy
2025-05-26 14:24:12
This appears to be a good quality 6" hose. I have used the 4" version of this hose, and it has worked out well. However, trying to connect this hose to a 6" Powertec coupling was a very difficult job. I ended up using a lubricant on both the coupling and inside the hose, and a thin screwdriver to pry the hose over the coupling. Sliding the hose over an aluminum 6" blast gate, which is a slightly smaller diameter, was only a slightly easier. I recently had a similar problem with 5" hose and fittings. (Not this brand of hose.)I have never had similar issues with 4" and smaller dust collector hose and fittings.
Patricia H.
2025-05-25 14:07:02
I needed a replacement hose for my Agri-Fab leaf Vac. I had already replaced my original hose w an expensive OEM hose. Granted this hose seams to be lighter material, however this makes it more flexible. This makes turning a lot easier and the hose subtracts better, so far the longer length is perfect as for my use the original hose I could only turn right. Now I can turn both ways. I am interested now in the long term durability. If I can get 2 seasons out of it it will definitely surpass my expectation's.So far great value for money and fits my setup perfectly.Yes it is a tight fit, I left it an hour in the sun and then it was very easy to fit
Darryl F.
2025-05-21 14:35:12
Good quality
Customer
2025-04-09 11:47:24
Product collapsed from suction and deformed. Very low quality
t.d.ham
2025-02-07 11:18:32
I bought this to replace my mow n vac hose. 6" clear flexible debris hose. Works great and the included clamps were nice too.Much more affordable than manufacturers replacement.I think the flexibility of this hose will make it last longer.
A. P.
2025-01-17 18:13:11
Purchased for my Agri-Fab lawn vac because I wanted the extra length - the 10' is perfect, lets me make turns both ways (left & right).1) Use a little grease or oil to slip over the outlet/inlets on your mower adapter and lawn vac2) Tighten down the clamps as tight as you can - I did not need to pin mine to the housings3) The hose is very flexible, even when the temp outside is not very warm4) The hose is puncture resistant5) After a short while, the inside of the hose gets dirty and that makes it more difficult to see the lawn debris flowing though it - I could only see the shadow of the flow when the sun hit the hose6) Now for the bad - the steel coiled wire was ripped out of the hose and wrapped around my impeller bringing it to an abrupt stop7) Had to disassemble the intake housing and remove the impeller to dislodge the tightly wound wire8) All that said, I preferred this hose to the one being sold by Agri-Fab as it was longer, lasted longer (most of the season as compared to the Agri-Fab that lasted 3 hours), was more flexible in varying temp conditions and is 1/2 the price of the Agri-Fab
Gary Darling
2024-11-13 12:28:40
Everything as advertised works well
Recommended Products