Your cart is empty.
Your cart is empty.Product Description
We are a professional auto parts manufacturer and have been focusing on auto parts since 2000. Our experienced auto professional team can help you find the correct parts you need and repair your vehicle. KingzAuto provides a wide range of replacement parts for many vehicles. And we'll keep putting new products on shelves one after another.
Applicable for Models (Links):
- 8531-III
- 8535-III
- 8935-DC-I
- 8940-DC-I
- 8935-DC-II
- 8940-DC-II
- 8935-DC-III
- 8940-DC-III
Compatible with Motor for Atwood, Hydro Flame RV Furnaces 37698
Strict Quality Control
All FEXON products undergo strict quality control.
Every furnace motor is tested quality before packing.
Fine Workmanship
The Product is fine workmanship, craftwork.
Precision is very high, product conformity is strong.
Perfect Fit and Attentive Service
Perfect meet OE specifications for fit, form, and function.
If there are any problems, we will help you to solve them as fast as possible.
Reece R Lowry
2025-09-03 11:30:43
It does work well however the diameter is just slightly smaller than oem and had to build a shim so it would fit tight in the bracket and not fall out.
markis jay greif
2025-08-28 10:12:50
It wasn’t to bad too install had to modify the key way to get the fan to fit on deeper but it’s still working and it’s quite
Gary Rossett
2025-08-14 14:20:05
This motor is a tad small to fit the clamps in the furnace and the long side of the shaft is too long. After a delay in getting the old one out (rust) I’m now stuck w the new one that doesn’t fit, due to the return policy only being 30days. Would not recommend for Atwood furnaces
Quinn Anderson
2025-07-17 14:37:38
My old Atwood hydro flame furnace motor was squealing, I replaced it with this and it is now quiet. The top "arm" was slightly longer than the one on the original motor, so I had to adjust things a bit but it works fine.
how0448
2025-07-04 15:20:10
as advertised. It is the right motor. not installed yet
the motor measured was not as on page
2025-06-30 10:26:12
took to much time and work to make it work
Reece R Lowry
2025-05-25 18:41:36
It does work well however the diameter is just slightly smaller than oem and had to build a shim so it would fit tight in the bracket and not fall out.
markis jay greif
2025-05-06 18:14:53
It wasn’t to bad too install had to modify the key way to get the fan to fit on deeper but it’s still working and it’s quite
Gary Rossett
2025-03-26 09:06:37
This motor is a tad small to fit the clamps in the furnace and the long side of the shaft is too long. After a delay in getting the old one out (rust) I’m now stuck w the new one that doesn’t fit, due to the return policy only being 30days. Would not recommend for Atwood furnaces
Quinn Anderson
2025-02-21 19:31:27
My old Atwood hydro flame furnace motor was squealing, I replaced it with this and it is now quiet. The top "arm" was slightly longer than the one on the original motor, so I had to adjust things a bit but it works fine.
how0448
2025-02-18 13:53:17
as advertised. It is the right motor. not installed yet
the motor measured was not as on page
2025-01-20 17:27:37
took to much time and work to make it work
Recommended Products