Shopping Cart

Your cart is empty.

Your cart is empty.

Greenlee 14722 Knockout Punch Die

Free shipping on orders over $29.99

$23.45

$ 11 .99 $11.99

In Stock

About this item

  • Round standard metal punch units are complete units consist of punch, die and draw stud
  • Use with battery-powered, Hydraulic, ratchet or manual drivers
  • Properly assembled through pilot holes, They will make clean, fast and accurate holes
  • Use with Greenlee punch model number 121AV
  • Can be used on mild steel up to 14 gauge


Product Description

10 gauge mild steel material; Knockout punch unit used on; 7/8 inch designated size; die; slug-buster used on model/Brand; 7306SB, 7310SB, 7646Pgsb, 38520, 7606SB, 7610SB used on item part No.; 1/2 inch Conduit/pipe size; Greenlee Brand

From the Manufacturer

Greenlee round standard replacement metal dies must be used with a matching punch and draw stud to operate. They can punch quick clean holes through metal up to 10 gauge (check specs for specific punches). They can be used with battery-powered, hydraulic, ratchet or manual drivers. Properly assembled through pilot holes, they will make clean, fast and accurate holes. After cutting the slug falls free in the die, and a quick tip drops it out.


Stephanie Dominguez
2025-08-28 16:34:54
As described. Fast shipping and good quality product
TERONUS
2025-08-10 18:16:42
I use this with hydraulic pull through head on 0.063 In. Type 304 stainless steel. Cuts better than the old-style punches and far easier to clear slugs.
Richard L. Christy
2025-07-21 14:52:36
If I can't tell the truth then don't ask me for a review
B K
2025-07-14 14:43:59
the part that was sent to me seemed like it was a used part and not even the right part. not even close to the right part as advertised. even had to paya good amount for shipping.
Collin Edwards
2025-07-01 20:13:35
Not what I wanted.
guna
2025-05-18 13:56:53
The product was and excellent.
Stephanie Dominguez
2025-03-19 17:16:58
As described. Fast shipping and good quality product
TERONUS
2025-03-05 18:38:04
I use this with hydraulic pull through head on 0.063 In. Type 304 stainless steel. Cuts better than the old-style punches and far easier to clear slugs.
Richard L. Christy
2025-03-02 13:30:17
If I can't tell the truth then don't ask me for a review
B K
2025-02-15 13:58:28
the part that was sent to me seemed like it was a used part and not even the right part. not even close to the right part as advertised. even had to paya good amount for shipping.
Collin Edwards
2025-01-09 16:06:10
Not what I wanted.
guna
2024-12-10 16:05:34
The product was and excellent.