Your cart is empty.
Your cart is empty.Beveled tip to provide proper alignment of the roll pin in the punch while gunsmithing. Drop forged, heat treated steel. Sizes: 1/16”, 5/64”, 3/32”, 1/8”, 5/32”, 3/16”, 7/32”, 1/4”, 5/16”. Includes roll-up storage pouch.
Michael Z. Williamson
August 18, 2025
I use these for assembling sport utility rifles. Makes it much easier to set the roll pins than needlenose and a hammer. I did have to grind on a bit shallower, but that's better than having to make one deeper.
Phillip Smith
August 12, 2025
As long as I keep them away from the knuckle heads who can break an anvil, they will last.
E C
August 10, 2025
These work great for starting roll pins
WilIiam G
July 25, 2025
received item as described
Joshua
July 2, 2025
The pins are to large and to deep. Tried using to install gas tube roll pin, and the starter pin was to deep. I had to use thread locker on a safety pin to get the roll pin out. There wasn't even enough of the pin sticking out to try to use needle nose pliers. Very dissatisfied. Please don't buy these!!!!!!
DGV Customer
June 13, 2025
Pretty decent set of punches for the money.
Anthony Haffner
March 19, 2025
Cant really say much, which isnt a bad thing. They shipped FAST, and I use them every day for inhibitor switch recalls at my job.
Jack Barber
December 4, 2024
Great quality product. Sturdy storage roll. Each tool labeled for sizing. Fast shipping. Good communications. Excellent seller.
Recommended Products
