Your cart is empty.
Your cart is empty.R8 Collet & Tool Tray This Convenient Tray Will Cut Down Set Up And Tool Changing Time. Operator Works More Organized. Easy To Install, Drill And Tap Two Holes In The Base Casting 1" Below The Degree Ring.
Jacob B.
September 6, 2025
Fit my bridgeport j head fine it requires drilling and tapping 2 holes in the base casting to mount it which shouldn't be an issue for anyone purchasing one of these. Feels a little cheaply made(I believe its cast aluminum) but it has been holding up fine so far. As long as you don't overload it with extra stuff I don't expect it to break. Its been holding a whole set of collets, a annular cutter adapter, and a keyless drill bit chuck for close to a year now with no issues
Larry
August 13, 2025
Not anodized as picture shows. Cheap flat black paint easily scratched.
P. Sullivan
August 2, 2025
I needed a collet holder, and I was going to make one from scratch. When I saw the price on this unit, SOLD! To be fair, I did have to machine the mounting surfaces, 2 of them, so it sat on the Bridgeport body, but as a machinist, that was simple. It mounts up nicely, holds my most used collets, PERFECT!
Jason N.
May 12, 2025
This little ditty is not too bad, but its not perfect either. The feet the mount it need to be massaged to mate up cleanly to the surface of a mill stand. This should not be needed due to the fact that any mill that is not a Bridgeport is a copy of a Bridgeport. It should be design intent that it mount directly to the mill stand, but you can massage it with a grinder, or a boring head if you have the time and gumption.
Tina
May 4, 2025
Works great
Shop owner
April 7, 2025
It's just an ok part. I had to grind and reshape the mounting ears to fit my mill base. The back holes to rack the collets are spaced to close together and the collets run into each other. A bit more spacing would have worked. All in all it'll work fine to organize what I have.
Spider Monkey
February 12, 2025
Works well
Ron Rhodes
January 11, 2025
Planed on mounting on a flat board. Was obviously intended to mount on a curved surface. Definitely not for a mini mill
Recommended Products
$90.16
$ 42 .99 $42.99