Your cart is empty.
Your cart is empty.-QR880 DUAL Brushed ESC: Suitable for 1:8 / 1:10 All purpose -Waterproof and dustproof for all weather races. -Please make sure to uninstall the cooling fan before using this ESC in water. -Clean and dry soon after use to avoid rusting the connectors. -Fully waterproof design for all conditions. (Note: Please clean and dry it after use for avoiding rusty connectors). -HOBBYWING patented copper heat-conductive plates attached to the MOSFET board allows the internal heat to be quickly transferred to the aluminum heat sink for great heat dissipation. -Built-in switch-mode BEC with cont. current of 4A. -Tunable drag brake and drag brake rate for different vehicles, tracks, and control feel. -Adjustable PWM frequency combined with advanced freewheeling (/DEO) technology guarantees great throttle linearity and driving feel. -9 levels of acceleration/ punch from soft to aggressive for different vehicles, tires and tracks. -Proportional brake with 9 levels of initial brake force, maximum brake force, and drag brake force. -Multiple protections: low-voltage cutoff protection, thermal protection, and throttle signal loss protection. -Separate programming port to easily connect the LED program card (purchase separately) to the ESC. -ESC programming via HOBBYWING LED Program Card (purchase separately). -WP-880-DUAL BRUSHED ESC has two outputs to drive 2 motors. When driving 2 motors simultaneously, the Turn of the motors needs to be increased.
rick
2025-08-26 16:24:54
Bought this for my trolling motor based on You Tube. It is very compact and is working perfectly except for one issue. With my original setup I can switch between a fast or slow speed. Installed the Hobbywing to the slow circuit only for fishing. The issue occurs when returning to slow speed from fast. The Hobbywing controller must be centered before continuing forceing me to retune trolling speed each time. Also, my control pot doesn’t have a defined center / neutral spot so I must fiddle with it before getting a reset.Will be keeping this Hobbywing as a backup but will try a PWM.
Dan
2025-08-06 14:06:26
Genuine product. Used for a Powerwheel remote control car conversion. I was thinking to myself, 80 amp, yea right! Well, I have pulled around 30 amp in tall grass with my 2 year old daughter on board, up hills and this controller barely was warm. Incredible speed control with PWM yields very precise speed control and smooth starts. The configurability is nice, with the ability to delay reverse until the second return stroke (training mode) as well as limiting reverse power percentage, etc. The 2 outputs are just wired in parallel, so not a huge feature, but it's one less connection to make if you have dual motors. Only ding I'll give it is for some reason if I set the battery mode to NiMh (figured that was closer than LiPo when using SLA batteries) the unit will shutdown after about 3 seconds of use, even with battery protection disabled. Whatever, it doesn't really matter as it works for my application in LiPo mode.
Eric F. Delos Santos
2025-07-14 20:34:24
At first, I wasn't quite sure about this ESC. But after doing some research, it's a perfect ESC for the Super Clod buster.
aksman
2025-07-04 21:41:54
I have purchased several of these for use as speed controllers on brushed trolling motors. They have worked great but suggest not using on motors larger than 50lbs thrust.
Joe
2025-05-10 09:12:12
This electronic speed control is a very nice and flexible unit. I have it installed on my Clodbuster with aftermarket motors. Great value. The only drawback is that you need a separate card to make adjustments to the ESC that are different from default settings. For example, the ESC is default setup for Lipo batteries. If you want to run NiMH batteries, you need to purchase the card to adjust. The link is below for the card. https://www.amazon.com/gp/product/B00AX69CCI/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1
Melissa Morisawa
2025-04-29 17:29:30
This is a fantastic option and budget friendly ESC from a reputable brand. I’ve used this ESC is a few of my RC’s and recommended to many friends. Easy to setup and works flawlessly.
Avid Shopper
2025-04-18 10:41:52
This lil ESC got my 20+ year old E-Maxx back on the road. Went in easily and works like a champ.
Cane
2025-04-06 10:39:37
Works flawlessly on 3s. I installed this esc in my "Clodbuster Black edition". It has a CPE Black Raven aluminum chassis, suspension links, steering rods, axle mounted steering servo, and rear steering blocks. Basically the only stocks parts are the axles, motors, and body.
Daniel Raymond
2025-03-30 20:41:40
Oui reçu ma commende
Item received missing cooling fan
2025-02-19 12:35:28
Item was incomplete. Missing cooling fan
Justin Yates
2025-02-02 11:39:54
I like the workability of this esc. You have to get the program card to modify the settings to the specs you need or to customize your project to your liking. The only thing I haven’t figured out yet is how the cooling fan mounts to the unit. I think there might be holes in the decorative grating as it comes with screws but I’m sure they made it simple and easy as they usually do. Good piece of kit for dual brushed motors for a wide range of RC vehicles!
Donovan
2025-01-07 18:17:02
Can't beat it for the price !
Thanh Nam Nguyen
2024-12-26 13:07:04
Fonctionne tres bien facile à utiliser une fois programmer
Recommended Products
