Your cart is empty.
Your cart is empty.Justin S
2025-08-25 11:00:31
Injora parts, great quality good price and look great can’t ask for more
eric
2025-07-30 12:48:37
Perfect fit, no issues
Devin Manahan
2025-07-28 10:19:22
This design is a lot better than some of the other brass knuckles I've seen because the pivot bolts don't use little brass spacers. Instead it uses the short hex screws to pivot on. This is nice because they are countersunk, giving you a little more clearance at the bottom as well as protecting the screws from getting damaged. Everything bolted up perfectly and the black finish is nice. Nice way to strengthen your SCX24 and add a little extra weight.
donkeh
2025-07-19 20:48:18
I had NHX and TOPCAD knuckles but this injora is best. Weighs more than the other 2. Machined to clear hex weights with the "brake rotor" (topcad didn't clear). Comes with one extra bushing. Bearings fit good, no wheel wobble (topcad wobbles). Finish is good. Threads were good, screws went in fully. I'm ordering another.
Pete Allen
2025-07-09 18:33:36
This will not work with the stock linkage. I think the threads on the balls are a different pitch than a standard m1.4. The included screws will thread in but the stock ball ends will not. If you have aftermarket steering linkage they will work fine.UPDATE: Ordered another set and this time it included new ball ends that screwed into the knuckles and the stock steering linkage snapped on still had to use the o-rings to take the slop out but that's okay had to do that on the stock ones too.My only other complaint is that they decrease the steering angle. This can be corrected with a Dremel.Updated to 4 starts
Derrick Mattox
2025-06-29 17:58:13
They fit the stock axles perfectlyðŸ‘ðŸ¾
Wayne Harrison
2025-06-26 10:44:19
These fit perfectly on my scx24 Chevy c10 and will fit any of the scx24 models . The bearing fit a tad loose in the hub but not causing any play problems. I like the black finish a posed to shiny brass. Happy with these hubs and half the price of other leading brands.
Matthew M.
2025-06-09 13:22:10
not compatible with INJORA ProSteer Double Joint 40g Front and 22g Rear Axle for 1/24 Axial SCX24 Upgrade
Bianca S.
2025-06-01 18:45:05
absolut perfekt verarbeitet. absolut passgenau. durch die versenkten schrauben (ohne hülsen) steht nix mehr oben und unten am schenkel darüber. ausserdem sind kugelkopf-schrauben dabei, falls man eine andere lenkstange verbauen will.
Diego gianuzzi
2025-01-08 18:03:34
Montano perfettamente su Axial scx24 aiutando ad abbassare il baricentro del modello, la qualità è ottima e la rifinitura in nero opaco li rende molto belli. Non hanno nulla da invidiare ai mozzi proposti da marchi più famosi e costano la metà !
Julien L.
2025-01-05 13:40:41
Fit and finish is great and all hardware needed is included.
Tyler mizzi
2025-01-03 18:53:38
One side fit and the other side the bores for the bearings are too small and do not fit the axial scx24 bearings bad quality control
Recommended Products
