Your cart is empty.
Your cart is empty.CHRIS KRONZ
2025-07-29 21:13:35
I wasnt too sure about using this so close to my headers but it holds up well and the wire loom I threaded through it has held up.
eDecisions
2025-06-29 13:32:00
Excellent product, used on starter wire on 67 automobile, tested with my finger over the flame on the stove, 4min and just got warm inside with no visible damage to sleeve, I’d recommend this.
Kiwi
2025-05-14 16:29:43
I used this to insulate a fuel line from excessive under-hood temperatures. Solves the problem and holds up well to the heat.
john
2025-04-24 11:24:38
looks great. i don't see any issues that should arise.
Customer
2025-03-31 11:57:34
Used it to cover a generator exhaust extension out of my garage and keep the heat down. Well..... its does that but filled my garage with rubber smoke. It smokes a lot. I'll give it 4 stars for doing what it claimed to do, keeping the heat contained, but the smoke is a deal breaker for me and I'll be removing it and replacing it with kevlar header wrap.
Chris F.
2025-03-29 16:53:49
I wasn’t holding out much hope as to this product’s claim of being able to withstand a constant 800 degrees and up to 1200 momentarily. I decided to test it with a heat gun that I own. The gun will only go up to 1100 degrees, but this product held up fine without any evidence of outgassing, smoking or catching on fire.Considering the price of ASTM/UL rated equivalents being in the 3X cost range, it was worth a try. I will report back if I encounter issues with it after installing.
BC
2025-02-17 16:23:00
I bought the 1 inch inside diameter and it is able to stretch to a little over 1.5 inches. It snaps right back into the smaller size once it is around the object which makes it very useful for going over fittings. It can be cut with normal scissors, but you need a little force, a razor or very sharp shears works better. I took loose pieces of the fiberglass and held it under a butane torch and they acted as typical fiberglass and did not catch fire, but did eventually melt. Great product.
Honest John
2025-01-18 19:39:28
Used on the clutch cable of a mustang which went over motor, past exhaust down to under. Slipped over small end and looks and works great to insulate from heat.
Guy savard
2024-12-21 11:15:54
Fonctionne vraiment très bien
JUAN D.
2024-12-13 19:47:09
Es excelente aislante de altas temperaturas, por ser de silicona por fuera y de fibra de vidrio en el interior, lo utilize como manga de un harnés de cables del auto que esta en la bahÃa del motor y pasa a un costado del escape del mismo y se tenia que blindar por el calor excesivo que irradia el escape.
Recommended Products