Your cart is empty.
Your cart is empty.* 4 Inch (100mm) Width - To Be Used On A 4 Inch Or Wider Vise * 14 Gauge (2.0 mm) Max Capacity For Steel, * 1/8 Inch (3mm) Aluminum * Removable Hardened Finger Dies: 1", 1" and 2" * VICE MOUNT; * Magnets mount for easy and convenient removable; * Vice NOT included
Javier Valdes
August 16, 2025
These are great for small jobs that don’t require a full sized press.
Adam L.
August 12, 2025
So far this little brake has worked amazingly well. I got it for a project where I needed to bend some 14g stainless steel and it handled it just fine despite it being the max rated material it can handle. Finish could be a bit better, but it's cast so I'm not complaining. Definitely worth the money for small fabrication jobs. Works way better than those folding brakes you get at harbor freight. Keep in mind since it's vice mounted it takes quite a bit of strength to bend thicker material. There's not a lot of leverage on a vice arm. But it is doable.
IMNoOne
July 29, 2025
This is a GREAT tool....in the right place. Bought this to do "Jog" or "Joggle" bends. The TOOL is wonderful, and it satisfied 1/2 of my needs. It can do 1/2 of my job, but I can't do the "reverse" "out" bend. HOWEVER..this IS A GREAT adapter for 1-plane bends.
Mr christopher hekimian
July 16, 2025
I’m using these products to bend 1/8†diameter steel rods. I think that this might be beyond what the priduct is designed for but it is doing the job- with a little bit of accommodation. I am happy with the product. I recommend using it with a rotatable vise that is mounted vertically on a vertical bar that can be clamped to your bench. Rhis has been working well for me.
edat
July 15, 2025
I had an idea that this tool exists, and I had a project with a lot of bends in .068 stainless. It was a lifesaver! Anybody who has tried to bend metal by clamping it in a vise and hammering it over — this is so much more precise and accurate!
Michael H Jank
May 12, 2025
Ease of use. Tough...bent 1/8" x 2" mild steel...with a cheater bar. Impressed!
dudeinin
May 10, 2025
does well for what its intended for
Alain Rivard
May 2, 2025
the steel finger is to soft it is bending and compressing under load, nice tool ,but cheap material.
Richard Cooper
April 21, 2025
Fabricated all sorts of brackets
Derek R.
March 28, 2025
Very useful device, easy to use and well made the bigger the vise you have the more versatile the folder can be.
A J Turrall
March 4, 2025
Not bad, magnets are a bit weedy but other than that good..
Jon n
February 26, 2025
For model making, small metal works, this works very well!Have used this vice brake to bend spring steel, with very accurate results. Be very precise and you can achieve perfection.Also heat and quench if bending spring steel.
Customer
February 17, 2025
Easy to order, prompt delivery. Very happy with the product. Magnets are strong and work well. Product works well.
Recommended Products
