Your cart is empty.
Your cart is empty.Introducing the new Secure Fit Pouring Shield, designed to minimize countertop messes while you're mixing. Featuring easy snap tabs that securely attach the pouring shield to your stainless steel mixing bowl, and a large angled ingredient slide which allows you to easily add your carefully measured ingredients. Fits all 4.5 and 5 Quart KitchenAid® Tilt Stand Mixers* with stainless steel bowls. * Sold separately.
Martin S.
September 6, 2025
I have a 4.5 quart mixer, stainless steel bowl, and the shield fits perfectly and snugly.Keeps ingredients you add inside the bowl, not on your counter or floor.Clear shield lets you see how things are going inside while keeping mess to a minimum.Highly recommended.
Aidan Lynch
September 1, 2025
Bakers need this.Got it for my girlfriend because she loves baking. It stops the powders from kicking back up at her. Works very well. Fits good and locks on and is stable. Very easy to remove.It’s also cheap and kitchen aide name brand. I recommend.
Mr Nobody
August 18, 2025
Excellent fit for the Kitchen aid mixer. Double check your model number before ordering.
Michelle Oelfke
July 14, 2025
This shield for my kitchenaid stand mixer works great! Its high quality plastic and the rubber gripper clips hold it securely to the bowl. The chute works well to add ingredients to the bowl. Only thing I wish the chute was a little bigger and the shield fully covered the back of the bowl.
uppitykatt
April 10, 2025
This is an excellent item. I just learned how to make butter with our Kitchenaid stand mixer. Previously, I used cut up paper plates to keep the buttermilk from flying out of the mixing bowl. I found this, bought it and it works perfectly, with one thing that should be done extra that would truly make this perfect.It has 2 large slots in it. One slot is for adding things to the mixing bowl. The second slot is to allow it to be removed. Both make sense. However, there needs to be some type of "cover" for these. Something that would snap on or slot in. Why?When doing something like making butter, you ramp up the speed and for the last 5 minutes you mix at high speed. By the final 3-5 minutes, the mixer is running at speed 8 or 10, the butter has been made, but the buttermilk has also been extracted. So, as this large hunk of butter is flying around in the bowl, it is splashing the buttermilk everywhere. At this point, you have to cover the two holes, otherwise buttermilk is splashing out of the mixer. To cover, I use a kitchen towel for the large hole and my hand for the adding hole. Your hand and the towel are then soaked. Not such a huge deal, but I get concerned that the mixer will grab the towel and drag it into the mix.By simply making two little caps to seal these openings, that makes a very good product great! They don't even have to seal tightly, they are just splash guards. While I relate this from a "making butter" standpoint, there are a lot of things that use liquids and high speed.Yes, I'd buy this again and would definitely recommend!
Kindle Customer
March 18, 2025
Fits well.
mark a austin
January 27, 2025
This guard works good to keep dry ingredients from spilling out over the sides when mixer is on.
Trudy
January 7, 2025
I love that I no longer have to cover my mixer with a towel when I'm making something that uses a lot of flour. This makes cleaning up a lot easier.
Recommended Products
$175.99
$ 85 .99 $85.99