Your cart is empty.
Your cart is empty.S.E.
2025-08-30 20:00:29
Item was received earlier than promised and worked flawlessly. Item is as described.Came with some Teflon tape, but was not needed.
Frank
2025-08-27 16:24:21
For some reason, the water line to my fridge ran off the hot water side under the kitchen sink. I used one to tee off the cold water faucet in the bathroom behind the refrigerator. I added this and a short line through the wall, and all is good. It is well made with a rubber gasket in the swivel nut. No leaks.
Bob M
2025-07-12 11:34:11
works good
Leo R Graywacz
2025-07-08 11:50:27
Made the installation of my Dishwasher a breeze. Removed the line from the hot to my faucet and placed this in it's place. Attached the faucet line to the top hookup and the Dishwasher to the 2nd. Works well.
William B
2025-05-30 15:45:57
Quality = good, rubber washer = made good seal . my advice is don't over tighten the connection - not necessary, just follow the installation instructions. And remember to use the plastic ferules plus sleeves on PEX - discard the brass ones
J Parker
2025-05-13 12:15:08
Fit nicely
Hoodis
2025-04-27 20:34:31
The Perfect Treasure of Gifts!👈🤤👉So much love in this valve... my heart overflowed with pure plinky LOVE!✌😛✌
Darth Daddy
2025-03-29 17:47:52
I recently picked up bidet and had trouble with the part that came with the kit with leaking. No matter how much tape or tightening I still was getting a small leak. Did some reading and discovered this part and it did the trick! Actually can’t understand why the bidet itself didn’t just come with this kind of part itself instead of the cheap plastic part it came with. Could’ve saved me the headache of trying to pinpoint a leak.
Tinman3
2025-03-13 14:11:20
These worked perfect and I didn't need to rework the water lines when adding an additional bathroom sink.
AlfinBC
2025-02-27 14:30:23
Was unable to attach bidet tee to bottom of my American Standard toilet bowl because of tight space although I was able to disconnect supply hose. This 3/8 inch tee fits the Blundell bidet. Had the install done in "15 minutes" because it is connected to water supply valve where there is plenty of room to work 😀 .
online customer
2025-01-20 10:56:36
Prompt adequate usage as per need. Thx.
Love it
2024-12-12 13:53:16
If you know you know it does the job that's why you buy it
S&N Markos (GTA)
2024-12-10 15:53:47
Used it to install a bidet. The bidet T is sized to be installed on the tank inlet which is hard to reach plus that T was metal and without a wing nut.Making the connection at the floor valve instead is readily accessible and less chance of leak. This product also came with Teflon tape and was priced right.It is worth mentioning the 3/8†NPT thread in North America is equivalent to the bidet hose of nominal 9/16â€!!
Recommended Products
