Shopping Cart

Your cart is empty.

Your cart is empty.

Legines Brass Inverted Flare Fitting, Barstock Brake Line 90 Degree Male Elbow, 5/16' Tube OD x 1/8' NPT Male, Pack of 2

4.3 (8) Write Review
Free shipping on orders over $29.99

$7.99

$ 3 .99 $3.99

In Stock

About this item

  • Adapts NPT male end to tube female end at a 90-degree angle.
  • Brass for corrosion resistance, ductility at high temperatures, and low magnetic permeability
  • For use with liquid petroleum (LP) and natural gas, refrigeration, hydraulic brake, trans-mission cooler lines, fuel, oil, air, lines, power steering.
  • Not for use in potable drinking water applications
  • Working pressure up to 2000psi depending on Tube (O.D),Will withstand burst pressure 5000psi with bundy-weld.


Product Description

1

2
We have our own factory, which can offer ODM & OEM service. The main series:

  • PIPE FITTINGS
  • HOSE BARB FITTINGS
  • 45°FLARE FITTINGS
  • COMPRESSION FITTINGS
  • PUSH-IN FITTINGS
  • DOT AIR BRAKE FITTINGS

Legines Brass Inverted Flare Fitting

Barstock Brake Line 90 Degree Male Elbow

  • Adapts NPT male end to tube female end at a 90-degree angle.
  • High quality CA360 brass with ductility at high temperatures, and low magnetic permeability has higher strength, higher hardness, corrosion resistance and stronger wear resistance than ordinary brass, meets the SAE standard.
  • Typical application: For use with liquid petroleum (LP) and natural gas, refrigeration, hydraulic brake, trans-mission cooler lines, fuel, oil, air, lines, power steering.
  • Material : CA360 / CA377
  • Note : Not allowed by federal law to be installed for potable water use in the U.S.A.

Inverted 90 Degree Male Elbow

Adapts NPT male end to tube female end at a 90-degree angle.

Inverted 90 Degree Male Elbow

High quality material

Deep threads

Advantage

402
100

Inverted Flare Series

Our factory has more models for you to choose from.


DwKr
August 14, 2025
Good as advertised good value
ACORN
August 1, 2025
I needed a fitting in a pinch... Amazon to the rescue... these fit and don't leak under high pressure.
Matthew
July 7, 2025
Used this to rebuild the brake lines on my 1954 GMC M211 military truck.
Fernwood
May 3, 2025
Seems to be average quality and will probably work for intended purpose (external fuel pump on motor home) of connecting fuel tank drain to fuel pump. Hard to find 3/8" reverse flange street el fitting.
james noles
April 7, 2025
It fit and I repaired my air compressor.
Robert M. Beyer
February 20, 2025
High quality brass fittings. Worked perfectly, absolutely nothing to complain about.
sombody
January 21, 2025
Brass 90° for kodiak brake caliper
Don Pierson
January 10, 2025
These came in a sealed bag as a pair but one was filthy inside requiring considerable cleaning to get it usable. The other was fine but not this one as shown in the photo.