Your cart is empty.
Your cart is empty.KA324
2025-08-18 11:38:46
I had a Sams stainless steel patio heater that the thermocouple went out. I searched high and low for a replacement and finally ended up ordering this. The barrel of the thermocouple was slightly smaller than the original so I put a few washers on with the nuts and it worked great. Got the heater working. The other wires and ends fit just fine. This one does have a threaded barrel where there are a lot on Amazon that look like smooth shafts with grooves. So if you need threaded give this a try.
stephen
2025-08-14 17:22:51
Perfect fit for my patio heater. The unit would not stay lit and was aggravating. Once I replaced with this and raised up the thermocouple a little higher into the flame, all is working now. Great product and great price
David D.
2025-08-03 16:01:29
It worked as a replacement on my older fire-sense patio heater, the diameter of the tip is a little smaller than the original but I was able to attach it. It's working so far but it's only been a week. The wires could have been a little longer to ease installation.
David Fiedler
2025-07-15 16:16:32
Works as advertised
Customer
2025-06-09 11:10:20
It is horrible to install and it worked for about two min. Worst product ever.
Mik Muller
2025-06-01 11:31:32
This thermopile kit was not identical to that which came out of my pole heater but being electrically equivalent and not too different mechanically I was able to install it with a minimum of trouble. It has been working fine!
Darrel Bridges
2025-05-24 15:19:35
I use this on my propane tank heater. I had to shorten the wires to make it fit but after that it works like it is made to. Good product for the price and would buy again
Gary G.
2025-05-06 11:20:51
The only mod I had to make was to add a small washer to either side (top and bottom) of the thermocouple. before mounting it into the burner/starter of the heater. The thermocouple seemed to be a better build than with what came with the unit. Also, the length of the lines were perfect for me.I had a 50/50 shot in the thermocouple working for me, but it was the tilt/dump switch...oh well. By the time I got every thing put back together, the other patio heater failed too. I was done -and they are now both owned by my neighbor.For those of you curious, both heaters were from Walmart's Mainstays lineup (7ft Mocha -no table design). I only paid $50 each on sale....so it wasn't an ordeal to simply let them go.It's strange there are not more threaded thermocouples for "7ft patio heaters".Note to seller -add imperial measurements to your post to eliminate questions.
Jose Angel Lara Jimenez
2025-05-05 11:00:42
Lo compre para una caldera Junquers de Bosch, ya sabÃa que no le valdrÃa pero adaptándola un poco al final está funcionando, hace su función.
Michael Schmidt
2025-03-08 20:53:03
Ich benötigte das Thermoelement zur Reparatur meines HGG110. Montage klappte einwandfrei. Verarbeitung des Elements ist absolut in Ordnung. Der Heizer läuft nun wieder hervorragend. Bin sehr zu frieden.
DG
2025-01-24 18:13:59
Worked a treat in fixing my Universal Innovations Sahara Table Top Patio Heater. Sensor was a bit narrower than original but a couple of washers was enough to get it installed.
Iris
2025-01-18 18:21:23
Alles bestens
Anne D.
2025-01-02 18:40:31
Our patio heater wasn’t igniting and it looked like the thermocouple was the problem.Found this one which matched exactly the one we removed.Arrived the next afternoon which meant we got the heater working before our garden party guests arrived.Fitted perfectly and arrived really quickly.
Recommended Products
