Your cart is empty.
Your cart is empty.Mishimoto Black Silicone Heater Hose Set are made with a dual layer combining high grade silicone and heat-resistant embedded fibers to provide efficient heat reduction and increased pressure tolerance and a lifetime of satisfaction. These hose kits are a direct OEM fit, and they come in black, blue, red, and limited edition orange to enhance the aesthetic appeal of virtually any engine bay. They are perfect match for aluminum radiator products.
Cassie
2025-08-17 17:38:49
Great hoses, pain to get back there and replace them though. I would recommend using worm gear hose clamps and replace the old pinch hose clamps while you are at it just to make sure you don’t have to get back there again anytime soon for a leak.
:D
2025-07-29 20:18:03
Perfect fit. I upgraded all of the other hoses first and the only remaining factory hoses started leaking so I ordered these as a replacement. Ive been running these for months with no issue. The installation only took 20 minutes.
Ahmed Aloul
2025-07-08 11:17:09
Hoses fit well and everything lines up properly. Had to trim one hose slightly but this is pretty common with silicone hoses in my experience. Makes the engine bay look cleaner when all your other hoses are already silicone.
Diego Hernando
2025-03-05 18:44:30
Great quality product I expect to last many years.
anthony L.
2025-02-17 12:55:36
High quality
Basic Buyer
2025-01-22 18:44:15
Fitment could be better. The hoses run short, #6 hose clamps were too small. I recommend using factory hose clamps.
Matt
2024-11-14 11:14:34
Installed on a 1994 Mazda Miata. Note that if your heater lines are factory, more likely than not these will be an absolute PITA to remove. Be especially careful of the hoses at the firewall, try to pull them off rather than squeeze them because you will crush the pipe underneath. Once installed they look great, and I don't have to worry about them leaking for another long while!
Recommended Products
$107.03
$ 50 .99 $50.99