Your cart is empty.
Your cart is empty.Backed by superior materials and rigorous testing, MOOG® sway bar bushings deliver reliable performance you can count on. MOOG problem-solving innovations ensure fast, hassle-free installation.
DaChinaMan
2025-08-21 10:01:11
This was an exact fit and made a world of difference over my old blown bushings. Easy to install and will probably last for a long while.
Denver Wilson
2025-08-05 16:30:20
Easy to install and great quality
Excellent
2025-07-26 15:38:27
Excellent
Mr.Hillyard
2025-07-04 21:40:04
The build quality is great made of high-quality rubber. Fitment is overall good and was easy to Install. The proformance is great stiffer than stock and feels great offroad.
JustAguy
2025-07-01 16:35:36
Easily installed in the driveway, didn't even have to jack up the truck. After removing the four 8mm bolts holding the fabric panel on (you may or may not have this peice, it makes no difference either way), it was simply a matter of removing the two 15mm nuts from each bushing bracket. I lubed the inside and outside of the bushing with silicone paste as well as the bar to avoid any squeeks. My original rubber bushings were slightly worn but not cracked after 107k miles. These moog bushings are a harder compound and are two peices that snap together. I didn't notice any real difference after a test drive but wasn't really expecting any. I had already replaced my upper control arms, sway bar end links, and inner and outer tie rods trying to cure a very subtle rattle noise in the suspension that apparently I'm the only one who can hear. Anyways, figured I might as well just replace all the bits while I had it apart. Should last another 100k miles now.Replacing these and/or the end links does not require alignment, unless it's off to begin with. Same can be said for the upper control arms, provided you can manhandle them out without removing the strut (it is possible).
Jeffery W. Donelson
2025-06-23 16:01:01
These are better than original. The two piece construction makes installation very easy. One piece of advice. Lubricate with 100% silicon grease or spray. Thanks petroleum based lubricants may damage them.
Robbie C.
2025-05-22 17:44:41
I replaced my old worn out bushings on my 2013 F-150 4x4 with these MOOG bushings and it was super easy. There was actually a noticeable difference in body roll immediately after installation even though my old bushings werent that bad, I could still notice the tightness of the new bushings. Go ahead and buy a set!
Salvador Hernández
2025-04-28 15:20:02
Muy buen producto
Jason
2025-04-19 16:22:44
Oddly old ones came off easy on my 2013 F150 FX4 . Even driver side. Under coating helped. I put some petroleum jelly on everything before hand to make it a slide back on easily.
Joey arseneau
2025-03-26 11:26:26
A+++++
Richard Lambert
2025-01-26 11:10:17
Great quality and made a big difference in my truck. My sway bar was shaking inside the old bushing, these new ones were a perfect fit and took away lots of the sideways roll I felt.
Noodles
2024-12-11 11:06:36
Easy to install. Upgrade over stock.
Customer
2024-12-07 18:16:05
Looks like a good bushing.However it said it would fit a 2010 Ford Raptor and they do not.They are way too big for this application.
Recommended Products
