Your cart is empty.
Your cart is empty.Backed by superior materials and rigorous testing, MOOG ball joints deliver reliable performance you can count on. MOOG problem-solving innovations ensure fast, hassle-free installation.
bigboyjon
2025-08-12 13:32:24
Good fit and look well made. i used on a 1999 silverado and the project turned out well.
Conrad
2025-07-12 11:54:50
Good replacement for oem. Grease fitting included.
Dmitri Reali
2025-06-20 11:40:52
Installed in September 2022. So far they work, unlike the upper ball joints installed at the same time.
Aaron
2025-06-12 15:38:25
Perfect fit on a 2007 Silverado 1500 2WD. The OEM ones are a pain to remove, but these insert very easily with a ball joint press. The fact that these are serviceable mean that they should last a very long time (unlike the OEM). They are built very sturdy. My one complaint was that AFTER the installation was finished and everything was put back together, while filling with grease, one of the ball joint dust boots had a hole in the side, so as it began to fill with grease it just squirted out the side from a location that would not likely have been damaged during installation (the dust boot is retracted inside the steel housing until you fill it with grease). I contacted Amazon and they are sending a replacement. I would recommend doing some kind of inspection before you install to prevent completing the job only to find out that one is defective.
Rc
2025-06-06 11:05:33
Thanks
Robert Walters
2025-03-29 10:27:11
I bought these for my 2010 Silverado. I’m sure the product is great and fine quality however while it says it fits it…come to find out for my year, make, and model there is no pressing the old ones out as they come factory pressed into the upper control arm. I’ll give it 5 stars though because they are high quality and customer service and shipping were top notch and the return was accepted with no issues.
Vera davis
2025-02-22 16:06:34
Good
Tim Jackson
2025-02-11 18:15:46
Installed the Moog K6541 into my 2016 GMC Sierra 1500 Denali, which has the cast iron control arms. These fit well and seem to be built strong. Replaced my worn out stock ball joints with 155kms on them. They are genuine MOOG and are greaseable. Using a ball joint press tool made the install very easy. I did both sides in 2 hours. Torqued to 37ft/lbs +130* as per oem spec.
Shawn B
2025-01-13 10:27:56
Fit my 2013 Silverado 1500. Double check the part on the moog website before ordering. Didn’t get any torque numbers with product or from website. Website gave me a number to call. Didn’t call got torque from other source. Both boxes were damaged in amazon package with rip in it. Didn’t lose any parts. Came with 90 degree grease nipple nut split pin and spring clip. Hopefully it lasts.
Jean-Marie Zucchini
2025-01-08 18:22:54
Ok sur mon Silverado 1500 2016 avec table en acier forgé.
Rod
2024-12-13 14:55:33
Perfect fit for my 2008 Escalade ESV
Sorrenson
2024-12-11 15:30:12
Installed easily however it is bizarre how they look with the low boot. It should be noted one had a "razor cur" in the boot so grease poured out . I sure as heck wasnt pressing it out , Will grease like normal and see if it lasts .
Recommended Products
