Your cart is empty.
Your cart is empty.Product Description
MOOKEERF Low Loss N Male to SMA Male Outdoor/Indoor Extension Cable
- MOOKEERF SMA male to N male cable is an excellent cable to connect outdoor antenna or remote antenna to indoor amplifier.
- N type connector allows you to connect devices with N female connector, such as antenna, wifi signal booster, ADS-B receivers,surge arrester etc.
- SMA connector allow you to connect devices with SMA female connector,such as 4G LTE modem /router /RF Radio to Antenna etc.
Low Loss Low SWR
- High density tinned copper braid shields of our rg58 sma to n cable supports better signal transfer with minimum signal loss over large distances and higher frequency use.VSWR≤1.15.
High Quality
- The inner conductor of this sma to n cable is made of solid copper,outer conductor is made of Aluminum foil and tinned copper braid.More than 95% shield performance,95% resistance to EMI and RFI.Weatherproof and flexible PVC jacket allows the sma cable exposure in outdoor harsh environments.
Stronger Connection
- The length of heat shrink tube that connect the rg58 cable and sma male to n male connector is upgraded to 2.2",which can better protect the connector from falling off.
APPLICATIONS
- wifi signal booster
- ADS-B receivers
- surge arrester
- 4G LTE modem
- wifi router
- ect.
Roger D. Goff
2025-08-27 18:26:31
Good price fast shipping excellent seller
darrell sikes
2025-07-14 14:29:06
Bought these for my Nano VNA. They work great
Patrick
2025-07-01 17:57:56
Works well / no problems
Pete
2025-06-20 14:33:46
I ordered the “MOOKEERF N Male to SMA Male Cable 50ft Low Loss RG58 SMA to N Cable 50 Ohm for WiFi Router, GPS Receiver, Antenna, Signal Booster Use†to review and to have on hand if needed during a cell booster installation effort. Unfortunately, I never ended up using the cable for the permanent install but am actually now regretting that decision. After reading some of the user results on testing, I believe this cable would most likely operate better than the included stock cable that came with the booster. The construction quality is very obvious when holding and inspecting the cable. The termination ends are as good, if not better than what is on the stock cable I used. I actually would have preferred the black color over the white stock cable I used. I have a 60-foot Rohn tower that I finally got brave enough to climb and have been installing various antennas and dishes. I will absolutely use this cable on a future install when it comes time to do so. 4 stars âï¸âï¸âï¸âï¸â€“ Average to Above Average – At least what you would expect based on the Product Page. Maybe a bit more. A solid product. Recommended.Explaining my rating system:5 stars âï¸âï¸âï¸âï¸âï¸â€“ Exceeded Expectations – Highly recommend product.4 stars âï¸âï¸âï¸âï¸â€“ Average to Above Average – At least what you would expect based on the Product Page. Maybe a bit more. A solid product. Recommended.3 stars âï¸âï¸âï¸â€“ Average to Below Average – A bit less than what you would expect based on the Product Page. Left feeling somewhat disappointed. Maybe you’ll feel differently but I cannot fully stand behind the product.2 stars âï¸âï¸â€“ Below Average – Incorrect, missing, or misleading information on the product page. Low quality or questionable safety issues. Not recommended.1 star âï¸â€“ Junk – A complete misrepresentation of the product advertised, severe quality or safety issues. Avoid at all costs.
Customer
2025-03-31 16:36:40
Working well.
SubjectiveObjective
2025-02-20 10:18:23
I’ve been using this cable for about a year to connect to a 70cm antenna with a power-switched mast-mounted amplifier at power levels up to 50W transmitted and have encountered no issues. It’s of good construction, well-terminated and has held up to outdoor use (though largely in the shade of large trees which reduce UV exposure). … no complaints!
Paul A Pongratz
2025-02-12 14:52:20
The jacket on this RG58 cable is quite supple and will no doubt resist abrasion. The SMA and N connectors are crimped on securely and sealed with copious lengths of adhesive lined heat shrink tubing. I used mine to connect two Yagi antennas to my 4G modem outdoors, on a mast. The 3' length is just enough for a decent drip loop and still having enough cable to allow proper spacing/orientation of the two antennas. I just added a few wraps of self fusing coaxial seal tape - the stuff we all use to weatherproof our connections - and now I have a proper setup for MIMO Yagi antennas. A great way to get rid of the factory provided omni directional antennas and get some efficiency on my installation! This is some really high quality coax...I'll definitely be purchasing additional cables from this vendor. An excellent price point for the quality I received.Happy signal hunting everyone - get yourself a set of these and you'll be headed in the right direction!
Whatya Needtoknow
2025-01-29 16:49:43
I needed some coax to get my antenna further Up on the Roof but I despise building coax and using SMA connectors in the end connectors I really don't like either so I was very happy when I found this cable it was the right length and the right price. The connectors are good quality and so is the coax because I swept the coax and it was super low loss at 800 MHz so this was a no-brainer purchase.
Recommended Products