Your cart is empty.
Your cart is empty.Our Solid Color Car flags are made of durable, knitted polyester and are double sided for longer life. The staff and window clip are made of nylon.
Char
2025-08-02 12:42:56
I got tired of looking for my SUV in the parking lot so I bought this blue flag for the reason. I didn’t want a saying on it . I think the flag will last long time because I roll it up in my SUV when not in use. It durable and easy to clean
H.R.
2025-05-13 15:09:11
Very well made. However, you will need to sew a tighter stitch closer to the pole so the wind doesn’t blow the flag off. I bought 6 flags for our lead cars driving to our Boy Scout summer camp. We drove 3 hours at 70 mph interstate driving. With sewing the reinforced stitch, the flags came back still intact and looking new.
wayne m.
2025-03-13 18:18:53
too small and hard to fit anyplace but on a car window.
MollyKnoll
2025-03-09 10:21:10
We had to bend the bottom a little to get on and off the window. But once that worked, everything was perfect. I can see it across the parking lot, it looks nice and I can find my car!
Dayna Coverston
2025-02-22 12:30:30
Very poorly made does not last long at all once out on car! The seems just rip out of it. I put vinyl on and it just stretches the vinyl right off. These do not hold up to the wind when the car of moving at all! Also this was just at 25-30 mph not going very fast!
Goofymusketeer
2025-01-23 17:00:50
I ordered a blue and a yellow set of flags. The yellow was made of two sewn together, while the blue was just a single piece of cloth. I was expecting the double-layered in blue as well. After driving my car at a maximum of 35 mph for approximately 15 miles, it is obvious that the blue did not hold up as well as the yellow. I'm glad I didn't use them for the long trip that I was planning. I am disappointed in the consistency of the product.
Davina
2025-01-21 18:19:33
Took a rode trip with these on the car and drove 5 states.. they held up pretty good.
Jill
2025-01-07 18:48:45
The slide fit tightly over the window with a foam buffer to prevent scratching. The pole itself is a little too long and a little too "bendy"... it bends at highway speeds and the flag slides to the end; we fixed with a couple of zipties. We printed the image using iron-on transfer sheets. This was a last minute purchase and was an inexpensive one, though, and it certainly did the trick!
Recommended Products
