Your cart is empty.
Your cart is empty.OTC's specially designed wheel bearing locknut sockets make Ford Dana 60 axle rounded locknuts easy to remove or install. OTC wheel bearing locknut sockets are formed from high-strength steel that is resistant to rounding out under high torque loads. Designed for use with 3/4 inch, square-drive MANUAL tools only. NOT intended for use with impact tools - use with impact tools will void the socket's warranty. 6 point, 2-9/16 inch (flat to flat) opening size. Measure locknut from flat to flat to determine socket size needed. 5 inches deep to ensure spindle clearance. Value is at the core of the OTC tool and equipment portfolio. For a simple repair or the most complex drivability concern, these award-winning tools universally solve problems faster, and at better value, than any other product line available. Whether it’s a specialty tool or unique piece of service equipment, OTC provides top solutions to modern automotive service challenges while increasing technicians’ productivity and shop profits.
O. Hansen
September 6, 2025
I bought this socket to do the rear hubs on my 1976 Ford F-250. It worked well. Some of these larger nuts have rounded corners and some have pointed corners. Be sure that you get the correct socket for what you have or it may not work. This OTC product is sturdily made. It has a 3/4" drive hole. You can get an adapter to fit other size drives. It is painted gray and is made in the U.S.A. The ad's photo is accurate. If you want to go cheaper, you can get a lighter, black one with a 1/2" drive, made in China, from NAPA @ $16.99 + tax. In my opinion, the OTC quality is worth a few dollars more. It is packaged in a clear preformed self-standing plastic case.
Michael A Busbee
July 22, 2025
would buy from again.Thanks
RB
July 21, 2025
Great for 12k dexter axles on my 40' gooseneck trailer. I use it to take off and put on spindle nuts and torque 110-120 foot lbs. Also use it to take off and put on outside dust cover for oil bath axles. Perfect 2.5" socket and durable for what i use it for.
Ashley a
June 19, 2025
Great value. I looked all over in town for this socket and could not find it anywhere. This socket was a life saver. It did the job. It is kinda heavy thick metal, what you would expect of a quality tool. It seems like it would last a long time with regular use.
Customer
June 18, 2025
It was what was recommended for doing the brakes on the back of my 93 dodge D250 worked perfectly
Customer
May 15, 2025
Another fine toll by OTC. Right price for those seldom used tools.
Mauricio
May 12, 2025
Good tool, I used it on a semi trailer hub and went up to 250lb/ft of torque while seating the bearings and not an issue at all.
Jared Dean
May 8, 2025
Accurate fit heavy duity. I'm a diesel mechanic and it holds up
Paul
April 15, 2025
This socket fit the rear axle nut on my '78 F-250 perfectly. Not a tool you need every day but certainly handy to have when you do.
Customer
March 2, 2025
Best wheel socket one could have for Dodge truck .
k
February 20, 2025
does the job, good price
Oleg
December 20, 2024
Excellent tool
ashwin
December 17, 2024
It's great price and quality tool
Recommended Products
$14.99
$ 7 .99 $7.99