Your cart is empty.
Your cart is empty.Product Description
Installation Steps
Mike B.
2025-07-19 10:59:16
I bought this to replace the belt on my Craftsman benchtop drill press. The original belt had a bad memory worn into it so it made extra noise and vibration when it ran, and always seemed to settle into the same spots. When I took it out, it was in a pare shape like it was still installed. Luckily I found this belt. I was a little concerned because this one is 3/8†and my original one was 5/16â€, but I couldn’t find a 5/16†link belt anywhere so I decided to take a chance on this one. I’m glad I did! It doesn’t come with any instructions, but it was easily adjustable after finding some videos on YouTube. Make sure to verify the correct direction of your machine pulleys as there is a correct direction for link belts to go and unlike some others, there are no arrows on the belt itself. But again, YouTube videos were my friend and I got it figured out and installed. I was nervous as this belt is a touch wider than the pulleys but to my surprise it runs great. The vibration is gone and it runs a fair amount quieter. There are no issues with slipping on the belt or anything of that sort. This works great and it has given my little drill press new life. I would happily purchase this link belt again.
TB
2025-06-12 15:03:16
Very handy for home made projects. Works very well and as described.
Don Stevens
2025-06-10 16:28:55
Product is well-manufactured. I have purchased these belts before with excellent performance. My benchtop drill press required a standard 3/8" belt. The product I received was only 3/8" larger by 1mm but it was enough to prevent the belt from seating property into the pulleys.
Greg G. Smith
2025-04-19 15:48:15
This is the best belt I have ever used on my table saw. It is easy to size and to install. It runs quiet and smooth. My saw never ran better.
RBY
2025-04-13 13:44:32
As good quality as the higher priced brands in my experience. I fitted this 3/8" belt to my drill press and my lathe. 1/2" belts run my band saw and table saw. It feels like there's more power output than with the smooth OEM belts, but that could be hopefulness. Still, these last forever yet are easily repaired if necessary, and fit very well.
David Anderson
2025-04-12 18:48:55
As described
Dave Carrington
2025-03-21 09:44:24
I put this on my 35 year old Delta table saw and it's like a different saw. No jumping at start-up or shut down. Very smooth operation with very little vibration and it seems quieter. It's easy to adjust and install. I'm truly impressed with this belt and recommend it.
replay
2025-01-07 13:27:15
I wanted to use it as a drive belt on a Billy Goat lawn vac because it seems they've built the machine around the drive belt. Very close tolerances around the drive belt retaining fingers prevent use of this very thick belt as an easy work-around alternative to completely disassembling the engine mount, transmission, blower housing, etc. to change the drive belt. Would've been so much easier...another great idea bubble popped.
Recommended Products